TLE75008-EMD_15 Datasheet, PDF (35/64 Pages) Infineon Technologies AG – SPI Driver for Enhanced Relay Control

TLE75008-EMD
Power Supply
Table 8 Electrical Characteristics Power Supply (cont’d)
V_DD = 3 V to 5.5 V, V_S = 7 V to 18 V, T_J = -40 °C to +150 °C, all voltages with respect to ground, positive currents
flowing as described in Figure 2 (unless otherwise specified)
Typical values: V_DD = 5 V, V_S = 13.5 V, T_J = 25 °C
Parameter
Symbol
Values
Unit Note /
Number
Min. Typ. Max.
Test Condition
Idle to Active delay
t_IDLE2ACTIVE –
Active to Idle delay
t_ACTIVE2IDLE –
Sleep to Limp Home delay t_SLEEP2LH –
Limp Home to Sleep delay t_LH2SLEEP –
100 200 µs
100 200 µs
300 600 µs
+t_ON +t_ON
200 400 µs
+t_OFF +t_OFF
1)
P_6.3.55
from INn or CSN
pins to MODE = 10_B
1)
P_6.3.56
from INn or CSN
pins to MODE = 11_B
1)
P_6.3.57
from INn pins
to V_DS = 10% V_S
1)
P_6.3.58
from INn pins to
Standard Diagnosis
= 0000_H (see
Chapter 10.6.1 for
details). External
pull-down SO to
GND required
Limp Home to Active delay t_LH2ACTIVE –
Active to Limp Home delay t_ACTIVE2LH –
50
100
µs
1)
P_6.3.59
from IDLE pin to
MODE = 10_B
50
100
µs
1)
P_6.3.60
from IDLE pin to
TER + INST register
= 8683_H (IN0 = IN1
= “high”) or
8682_H(IN1 = “high”,
IN0 = “low”) or
8681_H (IN1 = “low”,
IN0 = “high”) (see
Chapter 10.5 for
details)
Active to Sleep delay
t_ACTIVE2SLEEP –
50
100
µs
1)
P_6.3.61
from IDLE pin to
Standard Diagnosis
= 0000_H (see
Chapter 10.6.1 for
details). External
pull-down SO to
GND required.
1) Not subject to production test - specified by design
Data Sheet
35
Rev. 1.1, 2015-09-25