TLE75008-EMD_15 Datasheet, PDF (34/64 Pages) Infineon Technologies AG – SPI Driver for Enhanced Relay Control

TLE75008-EMD
Power Supply
Table 8 Electrical Characteristics Power Supply (cont’d)
V_DD = 3 V to 5.5 V, V_S = 7 V to 18 V, T_J = -40 °C to +150 °C, all voltages with respect to ground, positive currents
flowing as described in Figure 2 (unless otherwise specified)
Typical values: V_DD = 5 V, V_S = 13.5 V, T_J = 25 °C
Parameter
Symbol
Values
Unit Note /
Number
Min. Typ. Max.
Test Condition
Overall current consumption I_IDLE
–
in Idle mode
I_VS(IDLE) + I_VDD(IDLE)
Overall current consumption I_ACTIVE
–
in Active mode - channels
OFF
I I _VS(ACTIVE) + _VDD(ACTIVE)
Overall current consumption I_ACTIVE
–
in Active mode - channels ON
I I _VS(ACTIVE) + _VDD(ACTIVE)
Voltage difference between V_SDIFF
–
V_S and V_DD supply lines
Timings
–
2.5
–
4.5
–
4.5
200 –
mA IDLE = “high”
P_6.3.42
V_INn floating
f_SCLK = 0 MHz
HWCR.ACT = 0_B
OUT.OUTn = 0_B
DIAG_IOL.OUTn =
0_B
V_CSN = V_DD
mA IDLE = “high”
P_6.3.43
V_INn floating
f_SCLK = 0 MHz
HWCR.ACT = 1_B
OUT.OUTn = 0_B
DIAG_IOL.OUTn =
0_B
V_CSN = V_DD
mA IDLE = “high”
P_6.3.47
V_INn floating
f_SCLK = 0 MHz
HWCR.ACT = 1_B
OUT.OUTn = 1_B
DIAG_IOL.OUTn =
0_B
V_CSN = V_DD
mV ¹⁾
P_6.3.52
Sleep to Idle delay
t_SLEEP2IDLE –
200
400
µs
1)
P_6.3.53
from IDLE pin to
TER + INST register
= 8680_H (see
Chapter 10.6.1 for
details)
Idle to Sleep delay
t_IDLE2SLEEP –
100
200
µs
1)
P_6.3.54
from IDLE pin to
Standard Diagnosis
= 0000_H (see
Chapter 10.5 for
details)
external pull-down
SO to GND
required
Data Sheet
34
Rev. 1.1, 2015-09-25