GMS81C2112 Datasheet, PDF (85/107 Pages) Hynix Semiconductor – HYNIX SEMICONDUCTOR 8-BIT SINGLE-CHIP MICROCONTROLLERS

GMS81C2112/GMS81C2120
18. OSCILLATOR CIRCUIT
The GMS81C21xx has an oscillation circuits internally.
X_IN and X_OUT are input and output for main frequency re-
spectively, inverting amplifier which can be configured for
being used as an on-chip oscillator, as shown in Figure 18-
1.
C1
X_OUT
C2
4.19MHz
X_IN
V_SS
Recommend
Crystal Oscillator
Ceramic Resonator
C1,C2 = 20pF
C1,C2 = 30pF
Crystal or Ceramic Oscillator
Open
External Clock
X_OUT
X_IN
R_EXT
X_OUT
For selection R value,
X_IN
Refer to AC Characteristics
External Oscillator
RC Oscillator (mask option)
Figure 18-1 Oscillation Circuit
Oscillation circuit is designed to be used either with a ce-
ramic resonator or crystal oscillator. Since each crystal and
ceramic resonator have their own characteristics, the user
should consult the crystal manufacturer for appropriate
values of external components.
Oscillation circuit is designed to be used either with a ce-
ramic resonator or crystal oscillator. Since each crystal and
X_OUT
ceramic resonator have their own characteristics, the user
X_IN
should consult the crystal manufacturer for appropriate
values of external components.
In addition, see Figure 18-2 for the layout of the crystal.
Note: Minimize the wiring length. Do not allow the wiring to
intersect with other signal conductors. Do not allow the wir-
ing to come near changing high current. Set the potential of
the grounding position of the oscillator capacitor to that of
VSS. Do not ground it to any ground pattern where high cur-
rent is present. Do not fetch signals from the oscillator.
Figure 18-2 Layout of Oscillator PCB circuit
JUNE. 2001 Ver 1.00
79