HMC700LP4 Datasheet, PDF (26/36 Pages) Hittite Microwave Corporation – 8 GHz 16-Bit Fractional-N PLL

v07.0411
HMC701LP6CE
8 GHz 16-Bit Fractional-N PLL
Main Serial Port READ Operation
0
The synthesizer uses the multi-purpose pin, LD_SDO, for both Lock Detect and Serial Data Out (SDO) functions. The
registers lkd_to_sdo_automux_en (Reg1A<12>) and lkd_to_sdo_always (Reg1A<13> Table 36) determine how the
Data Output pin is muxed with the Lock Detect function. If both of the registers are cleared, then the pin is exclusively
SDO. If automux is enabled, the pin switches to SDO when the RD function is sensed on the 1st rising edge of SCLK.
If lkd_to_sdo_always is set, then the pin LD_SDO is dedicated for Lock Detect only, and it is not possible to read from
the synthesizer.
A typical READ cycle is shown in Figure 19.
a. The Master (host) asserts both SEN (Serial Port Enable) and SDI to indicate a READ
cycle, followed by a rising edge SCLK
b. The slave (synthesizer) reads SDI on the 1st rising edge of SCLK after SEN. SDI high initiates
the READ cycle (RD)
c. Host places the six address bits on the next six falling edges of SCLK, MSB first.
d. Slave registers the address bits on the next six rising edges of SCLK (2-7).
e. Slave places the 24 data bits on the next 24 rising edges of SCK (8-31), MSB first .
f. Host registers the data bits on the next 24 falling edges of SCK (8-31).
g. SEN is de-asserted on the 32nd falling edge of SCLK.
h. The 32nd falling edge of SCLK completes the cycle
Figure 19. Serial Port Timing Diagram - READ
For price, delivery and to place orders: Hittite Microwave Corporation, 2 Elizabeth Drive, Chelmsford, MA 01824
978-250-3343 tel • 978-250-3373 fax • Order On-line at www.hittite.com
Application Support: [e-mail]
0 - 26