MB81F643242B-10FN-X Datasheet, PDF (17/56 Pages) Fujitsu Component Limited. – MEMORY CMOS 4 X 512 K X 32 BIT SYNCHRONOUS DYNAMIC RAM

MB81F643242B-10FN-X Advanced Info (AE0.3E)
(Continued)
When the full burst operation is executed at single write mode, Auto-precharge command is valid only at write
operation.
The burst type can be selected either sequential or interleave mode. But only the sequential mode is usable to the
full column burst. The sequential mode is an incremental decoding scheme within a boundary address to be
determined by burst length, it assigns +1 to the previous (or initial) address until reaching the end of boundary
address and then wraps round to least significant address (= 0).
Burst
Length
2
4
8
Starting Column
Address
A2 A1 A0
XX0
XX1
X00
X01
X10
X11
000
001
010
011
100
101
110
111
Sequential Mode
0–1
1–0
0–1–2–3
1–2–3–0
2–3–0–1
3–0–1–2
0–1–2–3–4–5–6–7
1–2–3–4–5–6–7–0
2–3–4–5–6–7–0–1
3–4–5–6–7–0–1–2
4–5–6–7–0–1–2–3
5–6–7–0–1–2–3–4
6–7–0–1–2–3–4–5
7–0–1–2–3–4–5–6
Interleave
0–1
1–0
0–1–2– 3
1–0–3–2
2–3–0–1
3–2–1–0
0–1–2–3–4–5–6–7
1–0–3–2–5–4–7–6
2–3–0–1–6–7–4–5
3–2–1–0–7–6–5–4
4–5–6–7–0–1–2–3
5–4–7–6–1–0–3–2
6–7–4–5–2–3–0–1
7–6–5–4–3–2–1–0
FULL COLUMN BURST AND BURST STOP COMMAND (BST)
The full column burst is an option of burst length and available only at sequential mode of burst type. This full column
burst mode is repeatedly access to the same column. If burst mode reaches end of column address, then it wraps
round to first column address (= 0) and continues to count until interrupted by the news read (READ) /write (WRIT),
precharge (PRE), or burst stop (BST) command. The selection of Auto-precharge option is illegal during the full
column burst operation except write command at BURST READ & SINGLE WRITE mode.
The BST command is applicable to terminate the burst operation. If the BST command is asserted during the burst
mode, its operation is terminated immediately and the internal state moves to Bank Active.
When read mode is interrupted by BST command, the output will be in High-Z.
For the detail rule, please refer to TIMING DIAGRAM – 8.
When write mode is interrupted by BST command, the data to be applied at the same time with BST command will
be ignored.
BURST READ & SINGLE WRITE
The burst read and single write mode provides single word write operation regardless of its burst length. In this
mode, burst read operation does not be affected by this mode.
17