V2-EVAL Datasheet, PDF (28/64 Pages) Future Technology Devices International Ltd. – Vinculum II Evaluation Board

5.8
Document Reference No.: FT_000247
V2-EVAL Vinculum II Evaluation Board Datasheet Version 2.0
Clearance No.: FTDI#148
USB2 interface CN2.
Figure 5.13
USB2 Interface CN2
VNC2 USB2 transceiver pins are brought on this connector. Depending on the version of the firmware
running on the device, the port can be configured as host or slave port.
Signal
name
5V ⁽³⁷⁾
USB2-DM
USB2-DP
Connector
pin
number
VCN2 pin
name
1
-
2
USB2 DM
3
USB2 DP
VCN2 pin number
32-
PIN
20
21
48-
PIN
-
28
29
64-
PIN
36
37
IO
type
Description
-
5V power rail.
Can be used to power external devices
IO USB2 transceiver, data line Minus
IO USB2 transceiver, data line Plus
GND
4
-
-
-
Ground pin
Shield
5, 6
-
-
-
Connector shield. Connected to ground.
Notes:
(37)
This pin is connected to the board‟s 5V power rail. External device can draw no more than 250mA when
board is powered from power supply and no more than 50mA when the board is powered from USB power
bus.
Table 5.12 USB2 Host / Slave connector CN2
Copyright © 2010 Future Technology Devices International Limited
27