V2-EVAL Datasheet, PDF (18/64 Pages) Future Technology Devices International Ltd. – Vinculum II Evaluation Board

Document Reference No.: FT_000247
V2-EVAL Vinculum II Evaluation Board Datasheet Version 2.0
Clearance No.: FTDI#148
5.2.4 GPIO [24:31] Connector CN6
Figure 5.5
GPIO[24:31] Connector CN6
Signal name
Connecto
r pin _32-PIN
VCN2 Pin No
48-PIN
64-PIN
IO
type
Description
GPIO24 ⁽¹³⁾
1
-
35
GPIO25 ⁽¹³⁾
2
-
36
GPIO26 ⁽¹³⁾
3
-
37
GPIO27 ⁽¹³⁾
4
-
38
GPIO28 ⁽¹³⁾
5
-
41
GPIO29 ⁽¹³⁾
6
-
42
GPIO30 ⁽¹³⁾
7
-
43
GPIO31 ⁽¹³⁾
8
-
44
43
IO GPIO port, data bit 24
44
IO GPIO port, data bit 25
45
IO GPIO port, data bit 26
46
IO GPIO port, data bit 27
47
IO GPIO port, data bit 28
48
IO GPIO port, data bit 29
49
IO GPIO port, data bit 30
50
IO GPIO port, data bit 31
GND
9
-
-
-
- Ground pin
3.3V⁽¹⁴⁾
10
-
-
- 3.3V power rail.
GND
11
5V⁽¹⁵⁾
12
-
-
- Ground pin
-
-
- 5V power rail.
Notes:
(13)
(14)
(15)
All VNC2‟s IO pins can be driven from 3.3V LVTTL TTL logic levels.
The use of these pins for GPIO is set by the IOMUX on the VNC2 device. The pins are shared by other
connectors on the board. Care should be taken to ensure that pins are not driven from other headers
on the board.
This pin is connected to 3.3V regulator output. External device can draw no more than 100mA when
board is powered from an external power supply and no more than 50mA when the board is powered
from USB bus.
This pin is connected to the board‟s 5V power rail. External device can draw no more than 250mA when
board is powered from power supply and no more than 50mA when the board is powered from USB bus.
Table 5.4 GPIO port connector CN6
Copyright © 2010 Future Technology Devices International Limited
17