V2-EVAL Datasheet, PDF (27/64 Pages) Future Technology Devices International Ltd. – Vinculum II Evaluation Board

5.7
Document Reference No.: FT_000247
V2-EVAL Vinculum II Evaluation Board Datasheet Version 2.0
Clearance No.: FTDI#148
USB1 interface CN1
Figure 5.12
USB1 Interface CN1
VNC2 USB1 transceiver pins are brought on this connector. Depending on the firmware version this port
can be configured as host or slave port.
Signal
name
5V ⁽³⁶⁾
USB1-DM
Connector
pin
number
VCN2 pin
name
1
-
VCN2 pin number
32-
PIN
48-
PIN
-
64-
PIN
2
USB1 DM 17
25
33
IO
type
-
IO
Description
5V power rail. Can be used to power
external devices
USB1 transceiver, data line Minus
USB1-DP
3
USB1 DP 18
26
34
IO
USB1 transceiver, data line Plus
GND
4
-
-
-
Ground pin
Shield
Notes:
(36)
5, 6
-
-
-
Connector shield. Connected to
ground.
This pin is connected to the board‟s 5V power rail. External device can draw no more than 250mA when
board is powered from power supply and no more than 50mA when the board is powered from USB power
bus.
Table 5.11 USB1 Host/Slave Connector CN1
Copyright © 2010 Future Technology Devices International Limited
26