V2-EVAL Datasheet, PDF (16/64 Pages) Future Technology Devices International Ltd. – Vinculum II Evaluation Board

Document Reference No.: FT_000247
V2-EVAL Vinculum II Evaluation Board Datasheet Version 2.0
Clearance No.: FTDI#148
5.2.2 GPIO [8:15] Connector CN4
Figure 5.3
GPIO[8:15] Connector CN4
Signal name
GPIO8 ⁽⁶⁾
Connector
pin
1
VCN2 Pin No
32-PIN
-
48-PIN
-
64-PIN
19
IO
type
Description
IO GPIO port, data bit 8
GPIO9 ⁽⁶⁾
2
-
-
20
IO GPIO port, data bit 9
GPIO10 ⁽⁶⁾
3
-
-
22
IO GPIO port, data bit 10
GPIO11 ⁽⁶⁾
4
-
-
23
IO GPIO port, data bit11
GPIO12 ⁽⁶⁾
5
-
-
24
IO GPIO port, data bit 12
GPIO13 ⁽⁶⁾
6
-
-
25
IO GPIO port, data bit 13
GPIO14 ⁽⁶⁾
7
-
-
26
IO GPIO port, data bit 14
GPIO15 ⁽⁶⁾
8
-
-
27
IO GPIO port, data bit 15
GND
9
-
-
-
- Ground pin
3.3V⁽⁷⁾
GND
5V⁽⁸⁾
Notes:
(6)
(7)
(8)
10
-
-
11
-
-
12
-
-
-
- 3.3V power rail.
-
- Ground pin
-
- 5V power rail.
All VNC2‟s IO pins can be driven from 3.3V LVTTL TTL logic levels.
The use of these pins for GPIO is set by the IOMUX on the VNC2 device. The pins are shared by other
connectors on the board. Care should be taken to ensure that pins are not driven from other headers
on the board.
This pin is connected to 3.3V regulator output. External device can draw no more than 100mA when
board is powered from an external power supply and no more than 50mA when the board is powered
from USB bus.
This pin is connected to the board‟s 5V power rail. External device can draw no more than 250mA when
board is powered from an external power supply and no more than 50mA when the board is powered
from USB bus.
Table 5.2 GPIO[8:15] connector CN4
Copyright © 2010 Future Technology Devices International Limited
15