S9S12G64F0CLF Datasheet, PDF (797/1292 Pages) Freescale Semiconductor, Inc – Reference Manual and Data Sheet

16 KByte Flash Module (S12FTMRG16K1V1)
the command’s execution by writing a 1 to the CCIF bit in the FSTAT register (a 1 written by the user clears
the CCIF command completion flag to 0). When the user clears the CCIF bit in the FSTAT register all
FCCOB parameter fields are locked and cannot be changed by the user until the command completes (as
evidenced by the Memory Controller returning CCIF to 1). Some commands return information to the
FCCOB register array.
The generic format for the FCCOB parameter fields in NVM command mode is shown in Table 24-22. The
return values are available for reading after the CCIF flag in the FSTAT register has been returned to 1 by
the Memory Controller. Writes to the unimplemented parameter fields (CCOBIX = 110 and CCOBIX =
111) are ignored with reads from these fields returning 0x0000.
Table 24-22 shows the generic Flash command format. The high byte of the first word in the CCOB array
contains the command code, followed by the parameters for this specific Flash command. For details on
the FCCOB settings required by each command, see the Flash command descriptions in Section 24.4.6.
Table 24-22. FCCOB - NVM Command Mode (Typical Usage)
CCOBIX[2:0]
000
001
010
011
100
101
Byte
HI
LO
HI
LO
HI
LO
HI
LO
HI
LO
HI
LO
FCCOB Parameter Fields (NVM Command Mode)
FCMD[7:0] defining Flash command
6’h0, Global address [17:16]
Global address [15:8]
Global address [7:0]
Data 0 [15:8]
Data 0 [7:0]
Data 1 [15:8]
Data 1 [7:0]
Data 2 [15:8]
Data 2 [7:0]
Data 3 [15:8]
Data 3 [7:0]
24.3.2.12 Flash Reserved1 Register (FRSV1)
This Flash register is reserved for factory testing.
Offset Module Base + 0x000C
7
6
5
4
3
2
1
0
R
0
0
0
0
0
0
0
0
W
Reset
0
0
0
0
0
0
0
0
= Unimplemented or Reserved
Figure 24-17. Flash Reserved1 Register (FRSV1)
All bits in the FRSV1 register read 0 and are not writable.
MC9S12G Family Reference Manual, Rev.1.23
Freescale Semiconductor
799