English
Language : 

MC68HC908QB8 Datasheet, PDF (188/236 Pages) Freescale Semiconductor, Inc – To provide the most up-to-date information, the revision of our documents
Timer Interface Module (TIM)
ELSxB and ELSxA — Edge/Level Select Bits
When channel x is an input capture channel, these read/write bits control the active edge-sensing logic
on channel x.
When channel x is an output compare channel, ELSxB and ELSxA control the channel x output
behavior when an output compare occurs.
When ELSxB and ELSxA are both clear, channel x is not connected to an I/O port, and pin TCHx is
available as a general-purpose I/O pin. Table 16-2 shows how ELSxB and ELSxA work.
NOTE
After initially enabling a TIM channel register for input capture operation
and selecting the edge sensitivity, clear CHxF to ignore any erroneous
edge detection flags.
TOVx — Toggle-On-Overflow Bit
When channel x is an output compare channel, this read/write bit controls the behavior of the channel
x output when the counter overflows. When channel x is an input capture channel, TOVx has no effect.
1 = Channel x pin toggles on counter overflow.
0 = Channel x pin does not toggle on counter overflow.
NOTE
When TOVx is set, a counter overflow takes precedence over a channel x
output compare if both occur at the same time.
CHxMAX — Channel x Maximum Duty Cycle Bit
When the TOVx bit is at 1, setting the CHxMAX bit forces the duty cycle of buffered and unbuffered
PWM signals to 100%. As Figure 16-13 shows, the CHxMAX bit takes effect in the cycle after it is set
or cleared. The output stays at the 100% duty cycle level until the cycle after CHxMAX is cleared.
OVERFLOW
OVERFLOW
PERIOD
OVERFLOW
OVERFLOW
OVERFLOW
TCHx
CHxMAX
OUTPUT
COMPARE
OUTPUT
COMPARE
OUTPUT
COMPARE
OUTPUT
COMPARE
Figure 16-13. CHxMAX Latency
16.8.5 TIM Channel Registers
These read/write registers contain the captured counter value of the input capture function or the output
compare value of the output compare function. The state of the TIM channel registers after reset is
unknown.
In input capture mode (MSxB:MSxA = 0:0), reading the high byte of the TIM channel x registers (TCHxH)
inhibits input captures until the low byte (TCHxL) is read.
MC68HC908QB8 Data Sheet, Rev. 1
188
Freescale Semiconductor