MC68HC908QB8 Datasheet, PDF (120/236 Pages) Freescale Semiconductor, Inc – To provide the most up-to-date information, the revision of our documents

Enhanced Serial Communications Interface (ESCI) Module
13.4.1 Transmitter Interrupts
These conditions can generate interrupt requests from the ESCI transmitter:
• ESCI transmitter empty (SCTE) — The SCTE bit in SCS1 indicates that the SCDR has transferred
a character to the transmit shift register. SCTE can generate a transmitter interrupt request. Setting
the ESCI transmit interrupt enable bit, SCTIE, in SCC2 enables the SCTE bit to generate
transmitter interrupt requests.
• Transmission complete (TC) — The TC bit in SCS1 indicates that the transmit shift register and the
SCDR are empty and that no break or idle character has been generated. The transmission
complete interrupt enable bit, TCIE, in SCC2 enables the TC bit to generate transmitter interrupt
requests.
13.4.2 Receiver Interrupts
These sources can generate interrupt requests from the ESCI receiver:
• ESCI receiver full (SCRF) — The SCRF bit in SCS1 indicates that the receive shift register has
transferred a character to the SCDR. SCRF can generate a receiver interrupt request. Setting the
ESCI receive interrupt enable bit, SCRIE, in SCC2 enables the SCRF bit to generate receiver
interrupts.
• Idle input (IDLE) — The IDLE bit in SCS1 indicates that 10 or 11 consecutive 1s shifted in from the
RxD pin. The idle line interrupt enable bit, ILIE, in SCC2 enables the IDLE bit to generate interrupt
requests.
13.4.3 Error Interrupts
These receiver error flags in SCS1 can generate interrupt requests:
• Receiver overrun (OR) — The OR bit indicates that the receive shift register shifted in a new
character before the previous character was read from the SCDR. The previous character remains
in the SCDR, and the new character is lost. The overrun interrupt enable bit, ORIE, in SCC3
enables OR to generate ESCI error interrupt requests.
• Noise flag (NF) — The NF bit is set when the ESCI detects noise on incoming data or break
characters, including start, data, and stop bits. The noise error interrupt enable bit, NEIE, in SCC3
enables NF to generate ESCI error interrupt requests.
• Framing error (FE) — The FE bit in SCS1 is set when a 0 occurs where the receiver expects a stop
bit. The framing error interrupt enable bit, FEIE, in SCC3 enables FE to generate ESCI error
interrupt requests.
• Parity error (PE) — The PE bit in SCS1 is set when the ESCI detects a parity error in incoming
data. The parity error interrupt enable bit, PEIE, in SCC3 enables PE to generate ESCI error
interrupt requests.
13.5 Low-Power Modes
The WAIT and STOP instructions put the MCU in low power-consumption standby modes.
13.5.1 Wait Mode
The ESCI module remains active in wait mode. Any enabled interrupt request from the ESCI module can
bring the MCU out of wait mode.
If ESCI module functions are not required during wait mode, reduce power consumption by disabling the
module before executing the WAIT instruction.
MC68HC908QB8 Data Sheet, Rev. 1
120
Freescale Semiconductor