MC68HC908QB8 Datasheet, PDF (125/236 Pages) Freescale Semiconductor, Inc – To provide the most up-to-date information, the revision of our documents

Registers
NOTE
Writing to the RE bit is not allowed when the enable ESCI bit (ENSCI) is
clear. ENSCI is in ESCI control register 1.
RWU — Receiver Wakeup Bit
This read/write bit puts the receiver in a standby state during which receiver interrupts are disabled.
The WAKE bit in SCC1 determines whether an idle input or an address mark brings the receiver out
of the standby state and clears the RWU bit.
1 = Standby state
0 = Normal operation
SBK — Send Break Bit
Setting and then clearing this read/write bit transmits a break character followed by a 1. The 1 after the
break character guarantees recognition of a valid start bit. If SBK remains set, the transmitter
continuously transmits break characters with no 1s between them.
1 = Transmit break characters
0 = No break characters being transmitted
NOTE
Do not toggle the SBK bit immediately after setting the SCTE bit. Toggling
SBK before the preamble begins causes the ESCI to send a break
character instead of a preamble.
13.8.3 ESCI Control Register 3
ESCI control register 3 (SCC3):
• Stores the ninth ESCI data bit received and the ninth ESCI data bit to be transmitted.
• Enables these interrupts:
– Receiver overrun
– Noise error
– Framing error
– Parity error
Bit 7
Read: R8
Write:
Reset: U
6
5
T8
R
0
0
= Unimplemented
4
3
2
1
Bit 0
R
ORIE
NEIE
FEIE
PEIE
0
0
0
0
0
R
= Reserved U = Unaffected
Figure 13-11. ESCI Control Register 3 (SCC3)
R8 — Received Bit 8
When the ESCI is receiving 9-bit characters, R8 is the read-only ninth bit (bit 8) of the received
character. R8 is received at the same time that the SCDR receives the other 8 bits.
When the ESCI is receiving 8-bit characters, R8 is a copy of the eighth bit (bit 7).
T8 — Transmitted Bit 8
When the ESCI is transmitting 9-bit characters, T8 is the read/write ninth bit (bit 8) of the transmitted
character. T8 is loaded into the transmit shift register at the same time that the SCDR is loaded into
the transmit shift register.
MC68HC908QB8 Data Sheet, Rev. 1
Freescale Semiconductor
125