33888 Datasheet, PDF (14/40 Pages) Freescale Semiconductor, Inc – Quad High-Side and Octal Low-Side Switch for Automotive

ELECTRICAL CONNECTIONS
STATIC ELECTRICAL CHARACTERISTICS
Table 5. Static Electrical Characteristics (continued)
Characteristics noted under conditions 6.0 V ≤ V_PWR ≤ 27 V, 4.5 V ≤ V_DD ≤ 5.5 V, -40°C ≤ T_J ≤ 150°C unless otherwise noted.
Typical values noted reflect the approximate parameter means at T_A = 25°C under nominal conditions unless otherwise noted.
Characteristic
Symbol
Min
Typ
Max
Unit
CONTROL INTERFACE
Input Logic High Voltage ⁽²²⁾
Input Logic Low Voltage ⁽²²⁾
Input Logic Voltage Hysteresis (SI, CS, SCLK, IHS[0:3], ILS) ⁽²³⁾
V_IH
0.7 V_DD
–
–
V
V_IL
–
–
1.0
V
V_IN(HYS)
100
350
750
mV
Input Logic Pulldown Current (SI, SCLK, IHS[0:3], ILS, WDIN)
I_DWN
5.0
–
20
µA
Input Logic Pulldown Resistor (WAKE, RST)
Input Logic Pullup Current (CS, V_IN = 0.7 V_DD) ⁽²⁴⁾
R_DWN
I_UPC
100
200
400
kΩ
5.0
–
20
µA
Input Logic Pullup Current (FSI, V_IN = 3.5 V)
Wake Input Clamp Voltage (I_WICI < 2.5 mA) ⁽²⁵⁾
I_UPF
V_WIC
5.0
–
7.0
–
20
µA
14
V
Wake Input Forward Voltage (I_WICI = - 2.5 mA)
V_WIF
- 2.0
–
- 0.3
V
SO High-State Output Voltage (I_OH = 1.0 mA)
V_SOH
0.8 V_DD
–
–
V
FS, SO Low-State Output Voltage (I_OL = -1.6 mA)
V_SOL
–
0.2
0.4
V
SO Tri-State Leakage Current (CS ≥ 3.5 V)
Input Capacitance ⁽²⁶⁾
SO, FS Tri-State Capacitance ⁽²³⁾
I_SOLK
C_IN
C_SO
- 5.0
0
5.0
µA
–
4.0
12
pF
–
–
20
pF
Notes
22. Upper and lower logic threshold voltage range applies to SI, CS, SCLK, RST, IHS[0:3], ILS, WAKE, and WDIN input signals. The WAKE,
FSI, and RST signals are derived from an internal supply.
23. Parameter is guaranteed by design but is not production tested.
24. CS is pulled up to V_DD.
25. The current must be limited by a series resistor when using voltages higher than the W_ICV.
26. Input capacitance of SI, CS, SCLK, RST, IHS[0:3], ILS, WAKE, and WDIN. This parameter is guaranteed by process monitoring but is
not production tested.
33888
14
Analog Integrated Circuit Device Data
Freescale Semiconductor