KX022-1020 Datasheet, PDF (7/75 Pages) List of Unclassifed Manufacturers – Accelerometer Specifications

± 2g / 4g / 8g Tri-axis Digital
Accelerometer Specifications
PART NUMBER:
KX022-1020
Rev. 11.0
10-Sep-15
Electrical
(Specifications are for operation at VDD = 2.5V and T = 25°C unless stated otherwise)
Parameters
Units
Min
Typical
Max
Supply Voltage (VDD) Operating
V
1.71
2.5
3.6
I/O Pads Supply Voltage (IO_VDD)
V
1.7
VDD
High Resolution Mode (RES = 1)
145
Current Consumption Low Power Mode¹ (RES = 0)
A
10
Standby
0.9
Output Low Voltage (IO_VDD < 2V)²
V
-
-
0.2 * IO_VDD
Output Low Voltage (IO_VDD ≥ 2V)²
V
-
-
0.4
Output High Voltage
V 0.8 * IO_VDD
-
-
Input Low Voltage
V
-
-
0.2 * IO_VDD
Input High Voltage
V 0.8 * IO_VDD
-
-
Input Pull-down Current
A
0
Start Up Time³
ms
2.0
650
Power Up Time⁴
ms
10
I²C Communication Rate
MHz
3.4
SPI Communication Rate
MHz
10
Output Data Rate (ODR)⁵
Hz
0.781
50
1600
Bandwidth (-3dB)⁶
RES = 0
RES = 1
Hz
800
Hz
ODR/2
Table 2: Electrical Specifications
Notes:
1. Current varies with Output Data Rate (ODR) as shown the chart below, and with Noise
level settings. Contact Kionix Engineering for additional details on FlexSet™
Performance Optimization.
2. For I²C communication, this assumes a minimum 1.5K pull-up resistor on SCL and
SDA pins.
3. Startup time is from PC1 set to valid outputs. Time varies with Output Data Rate
(ODR); see chart below
4. Power up time is from VDD valid to device boot completion.
5. User selectable through I²C or SPI.
6. User selectable and dependent on ODR and RES.
36 Thornwood Dr. – Ithaca, NY 14850
tel: [phone] – fax:[phone]
www.kionix.com - [e-mail]
© 2015 Kionix – All Rights Reserved
Page 7 of 75