OXCB950 Datasheet, PDF (8/68 Pages) List of Unclassifed Manufacturers – Integrated High Performance UART Cardbus / PCI interface

OXFORD SEMICONDUCTOR LTD.
OXCB950
UART pins
49
42
44
47
48
46
45
43
37
36
Dir¹
T_O
T_I
T_I
T_I
T_O
T_O
T_O
T_O
T_I
T_I
T_I
T_I
T_I
O
I
Name
Description
EXT_DATA_OUT UART serial data output
IrDA_Out
EXT_DATA_IN
UART IrDA data output when MCR[6] of the corresponding
channel is set in enhanced mode
UART serial data input
IrDA_In
DCD#
DTR#
UART IrDA data input when IrDA mode is enabled (see
above)
Active-low modem data-carrier-detect input
Active-low modem data-terminal-ready output. If automated
DTR# flow control is enabled, the DTR# pin is asserted and
deasserted if the receiver FIFO reaches or falls below the
programmed thresholds, respectively.
485_En
In RS485 half-duplex mode, the DTR# pin may be
programmed to reflect the state of the the transmitter empty
bit to automatically control the direction of the RS485
transceiver buffer (see register ACR[4:3])
Tx_Clk_Out
RTS#
CTS#
DSR#
Transmitter 1x clock (baud rate generator output). For
isochronous applications, the 1x (or Nx) transmitter clock
may be asserted on the DTR# pins (see register CKS[5:4])
Active-low modem request-to-send output. If automated
RTS# flow control is enabled, the RTS# pin is deasserted
and reasserted whenever the receiver FIFO reaches or falls
below the programmed thresholds, respectively.
Active-low modem clear-to-send input. If automated CTS#
flow control is enabled, upon deassertion of the CTS# pin,
the transmitter will complete the current character and enter
the idle mode until the CTS# pin is reasserted. Note: flow
control characters are transmitted regardless of the state of
the CTS# pin.
Active-low modem data-set-ready input. If automated DSR#
flow control is enabled, upon deassertion of the DSR# pin,
the transmitter will complete the current character and enter
the idle mode until the DSR# pin is reasserted. Note: flow
control characters are transmitted regardless of the state of
the DSR# pin
Rx_Clk_In
RI#
External receiver clock for isochronous applications. The
Rx_Clk_In is selected when CKS[1:0] = ‘01’.
Active-low modem Ring-Indicator input
Tx_Clk_In
XTLO
XTLI
External transmitter clock. This clock can be used by the
transmitter (and indirectly by the receiver) when CKS[6]=’1’.
Crystal oscillator output
Crystal oscillator input (10MHz – 40 MHz) or external clock
pin. Maximum frequency 60MHz
Data Sheet Revision 1.1
Page 8