English
Language : 

EP2S180F1508I4 Datasheet, PDF (128/238 Pages) Altera Corporation – Section I. Stratix II Device Family Data Sheet
Document Revision History
the Device & Pin Options dialog box in the Quartus II software uses a
32-bit CRC circuit to ensure data reliability and is one of the best options
for mitigating SEU.
You can implement the error detection CRC feature with existing circuitry
in Stratix II devices, eliminating the need for external logic. For Stratix II
devices, CRC is computed by the device during configuration and
checked against an automatically computed CRC during normal
operation. The CRC_ERROR pin reports a soft error when configuration
SRAM data is corrupted, triggering device reconfiguration.
Custom-Built Circuitry
Dedicated circuitry is built in the Stratix II devices to perform error
detection automatically. This error detection circuitry in Stratix II devices
constantly checks for errors in the configuration SRAM cells while the
device is in user mode. You can monitor one external pin for the error and
use it to trigger a re-configuration cycle. You can select the desired time
between checks by adjusting a built-in clock divider.
Software Interface
In the Quartus II software version 4.1 and later, you can turn on the
automated error detection CRC feature in the Device & Pin Options
dialog box. This dialog box allows you to enable the feature and set the
internal frequency of the CRC between 400 kHz to 50 MHz. This controls
the rate that the CRC circuitry verifies the internal configuration SRAM
bits in the FPGA device.
For more information on CRC, refer to AN 357: Error Detection Using CRC
in Altera FPGA Devices.
Document
Table 3–7 shows the revision history for this chapter.
Revision History
Table 3–7. Document Revision History (Part 1 of 2)
Date and
Document
Version
Changes Made
May 2007, v4.2 Moved Document Revision History section to the end
of the chapter.
Updated the “Temperature Sensing Diode (TSD)”
section.
Summary of Changes
—
—
3–14
Stratix II Device Handbook, Volume 1
Altera Corporation
May 2007