AKD4955-A Datasheet, PDF (19/89 Pages) Asahi Kasei Microsystems – AK4955 Evaluation Board Rev.3

[AKD4955-A]
Control Soft Manual
■ Evaluation Board and Control Soft Settings
1. Set an evaluation board properly.
2. Connect a PC and an evaluation board.
3. The USB control is recognized as HID (Human Interface Device) on the PC.
It is not necessary to install a new driver.
4. Start up the control program. (Note 17)
Note 17.The AK4955 should be reset by the PDN pin after the power supplies are applied.
After that, “Dummy Command” should be executed.
5. Proceed evaluation by following the process below.
<KM104703>
Figure 29.Window of Control Soft
- 19 -
2011/08