P0103 Datasheet, PDF (9/50 Pages) AEL Crystals Ltd – Introduction of the VEEK-MT

Figure 1-2 VEEK-MT kit package contents
1.2 Setup License for Terasic Multi-touch IP
To utilize the multi-touch panel in a Quartus II project, a Terasic Multi-Touch IP is required. After a
license file for Quartus II is installed, there is one more license file needed to implement Terasic’s
Multi-touch IP. Error messages will be displayed if the license file is not added before compiling
projects using Terasic Multi-touch IP. The license file is located at:
VEEK-MT System CD\License\license_multi_touch.dat
There are two ways to install the License. The first one is to add the license file
(license_multi_touch.dat) to the licensed file listed in Quartus II, as shown in Figure 1-3.
Figure 1-3 License Setup
The second way is to add license content to the existing license file. The procedures are listed
below:
Use Notepad or other text editing software to open the file license_multi_touch.dat.
VEEK-MT User Manual
6
www.terasic.com
May 20, 2014