P0103 Datasheet, PDF (26/50 Pages) AEL Crystals Ltd – Introduction of the VEEK-MT

Figure 4-2 Block diagram of the Painter demonstration
 Demonstration Source Code
 Project directory: Painter
 Bit stream used: Painter.sof
 Nios II Workspace: Painter \Software
 Demonstration Batch File
Demo Batch File Folder: Painter \demo_batch
The demo batch file includes the following files:
 Batch File: test.bat, test.sh
 FPGA Configure File: Painter.sof
 Nios II Program: Painter.elf
 Demonstration Setup
 Make sure Quartus II and Nios II are installed on your PC
 Power on the DE2-115 board
 Connect USB-Blaster to the DE2-115 board and install USB-Blaster driver if necessary
 Execute the demo batch file “test.bat” under the batch file folder, Painter \demo_batch
 After Nios II program is downloaded and executed successfully, you will see a painter GUI in
the LCD. Figure 4-3 shows the GUI of the Painter Demo.
VEEK-MT User Manual
23
www.terasic.com
May 20, 2014