P0103 Datasheet, PDF (6/50 Pages) AEL Crystals Ltd – Introduction of the VEEK-MT

o 3.5mm line-in, line-out, and microphone-in jacks
 Character Display
o 16x2 LCD module
 On-board Clocking Circuitry
o Three 50MHz oscillator clock inputs
o SMA connectors (external clock input/output)
 SD Card Socket
o Provides SPI and 4-bit SD mode for SD Card access
 Two Gigabit Ethernet Ports
o Integrated 10/100/1000 Ethernet
 High Speed Mezzanine Card (HSMC)
o Configurable I/O standards (voltage levels: 3.3/2.5/1.8/1.5V)
 USB Type A and B
o Provides host and device controller compliant with USB 2.0
o Supports data transfer at full-speed and low-speed
o PC driver available
 40-pin Expansion Port
o Configurable I/O standards (voltage levels: 3.3/2.5/1.8/1.5V)
 VGA-out Connector
o VGA DAC (high speed triple DACs)
 DB9 Serial Connector
o RS232 port with flow control
 PS/2 Connector
o PS/2 connector for connecting a PS2 mouse or keyboard
 TV-in Connector
o TV decoder (NTSC/PAL/SECAM)
 Remote Control
o Infrared receiver module
 Power
o 12V DC input
o Switching and step-down regulators LM3150MH
 Capacitive LCD Touch Screen
 Equipped with an 7-inch Amorphous-TFT-LCD (Thin Film Transistor Liquid Crystal Display)
module
 Module composed of LED backlight
 Support 24-bit parallel RGB interface
 Converting the X/Y coordination of touch point to its corresponding digital data via the Touch
controller.
Table 1-1 shows the general physical specifications of the touch screen (Note*).
VEEK-MT User Manual
3
www.terasic.com
May 20, 2014