P0103 Datasheet, PDF (42/50 Pages) AEL Crystals Ltd – Introduction of the VEEK-MT

Figure 4-16 Block diagram of the digital accelerometer demonstration
 Demonstration Source Code
 Project directory: G_sensor
 Bit stream used: G_sensor.sof
 Nios II Workspace: G_sensor\Software
 Demonstration Batch File
Demo Batch File Folder: G_sensor\demo_batch
The demo batch file includes the following files:
 Batch File: test.bat, test.sh
 FPGA Configure File: G_sensor.sof
 Nios II Program: G_sensor.elf
 Demonstration Setup
 Load the bit stream into the FPGA on the VEEK-MT.
 Run the Nios II Software under the workspace G_sensor\Software (Note*).
 After the Nios II program is downloaded and executed successfully, a prompt message will be
VEEK-MT User Manual
39
www.terasic.com
May 20, 2014