P0103 Datasheet, PDF (40/50 Pages) AEL Crystals Ltd – Introduction of the VEEK-MT

 Demonstration Source Code
 Project directory: VIP_Camera
 Bit stream used: VIP_Camera.sof
 Nios II Workspace: VIP_Camera \Software
 Demonstration Batch File
Demo Batch File Folder: VIP_Camera\demo_batch
The demo batch file includes the following files:
 Batch File: test.bat, test.sh
 FPGA Configure File: VIP_Camera.sof
 Nios II Program: VIP_Camera.elf
 Demonstration Setup
 Connect the VGA output of the VEEK-MT to a VGA monitor (both LCD and CRT type of
monitors should work)
 Load the bit stream into FPGA (note*)
 Run the Nios II and choose VIP_Camera\Software as the workspace. Click on the Run button
(note *)
 The system enters the FREE RUN mode automatically. Press KEY[0] on the DE2-115 board to
reset the circuit
 Press KEY[2] to stop run; you can press KEY[3] again to switch back to FREE RUN mode
and you should be able to see whatever the camera captures on the VGA display
 User can use SW[17] to mirror image of the line. However, remember to press KEY[0] after
toggle SW[17]
 Press and drag the video frame box will result in scaling the playing window to any size, as
shown in Figure 4-10
Note:
(1).Execute VIP_Camera\demo_batch\VIP_CameraA.bat will download .sof and .elf files.
(2).You may need additional Altera VIP suite Megacore license features to recompile the project.
Figure 4-15 illustrates the setup for this demonstration.
VEEK-MT User Manual
37
www.terasic.com
May 20, 2014