DS593 Datasheet, PDF (14/35 Pages) Xilinx, Inc – Includes innovative FPGA-based acceleration

Platform Cable USB II
Target Interface Connectors
Mating connectors for attachment of the high-performance ribbon cable to a target system are available in both through-hole
and surface mount configurations (Figure 14). Shrouded and keyed versions should always be used to guarantee proper
orientation when inserting the cable. The connector requires only 105 mm² of board space.
The target system voltage applied to pin 2 of this connector is used as a power source for the output buffers that drive the
output pins (see Target Interface Reference Voltage and Signals, page 19).
Table 5, page 14 provides some third-party sources for mating connectors that are compatible with the Platform Cable USB
II ribbon cable.
X-Ref Target - Figure 14
6.30 mm
7.59 mm
SPI
WP
NC
MOSI
MISO
SCK
SS
Vref
Slave
Serial JTAG
INIT
NC
DIN
DONE
CCLK
PROG
Vref
HALT 14
NC 12
TDI 10
TDO 8
TCK 6
TMS 4
Vref 2
2.00 mm
13 PGND
11 GND
9 GND
7 GND
5 GND
3 GND
1
12.00 mm
2.00 mm
TYP.
16.66 mm
0.50 mm
Figure 14: Target Interface Connector Dimensions and Signal Assignments
DS593_14_012508
Table 5: Mating Connectors for 2 mm pitch, 14-Conductor Ribbon Cable
Manufacturer⁽¹⁾
SMT,
Vertical
Through-Hole,
Vertical
Through-Hole,
Right Angle
Molex
87832-1420
87831-1420
87833-1420
FCI
98424-G52-14
98414-G06-14
98464-G61-14
Comm Con Connectors
2475-14G2
2422-14G2
2401R-G2-14
Web Site
www.molex.com
www.fciconnect.com
www.commcon.com
Notes:
1. Some manufacturer pin assignments do not conform to Xilinx pin assignments. Please refer to the manufacturer’s data sheet for more
information.
2. Additional ribbon cables can be purchased separately from the Xilinx Online Store.
DS593 (v1.2.1) March 17, 2011
www.xilinx.com
14