DS90UB929-Q1 Datasheet, PDF (54/71 Pages) Texas Instruments – 720p HDMI to FPD-Link III Bridge Serializer

DS90UB929-Q1
SNLS457 – NOVEMBER 2014
www.ti.com
Register Maps (continued)
ADD
(dec)
199
ADD
(hex)
0xC7
Register Name
ISR
240
0xF0 TX ID
241
0xF1
242
0xF2
243
0xF3
244
0xF4
245
0xF5
Bit(s)
7
6
5
4
3
2
1
0
7:0
7:0
7:0
7:0
7:0
7:0
Table 8. Serial Control Bus Registers (continued)
Register
Type
R
R
R
R
R
R
R
R
R
R
R
R
R
R
Default
(hex)
0x00
0x5F
0x55
0x42
0x39
0x32
0x39
Function
Description
IS_IND_ACC Interrupt on Indirect Access Complete: Indirect Register Access has completed.
IS_RXDET_IN Interrupt on Receiver Detect interrupt: A downstream receiver has been detected.
T
IS_RX_INT
Interrupt on Receiver interrupt: Receiver has indicated an interrupt request from down-
stream device.
IS_LIST_RDY Interrupt on KSV List Ready: The KSV list is ready for reading by the controller.
IS_KSV_RDY Interrupt on KSV Ready: The Receiver KSV is ready for reading by the controller.
IS_AUTH_FAI Interrupt on Authentication Failure: Authentication failure or loss of authentication has
L
occurred.
IS_AUTH_PAS Interrupt on Authentication Pass: Authentication has completed successfully.
S
INT
Global Interrupt: Set if any enabled interrupt is indicated.
ID0
First byte ID code: "_".
ID1
Second byte of ID code: "U".
ID2
Third byte of ID code: "B".
ID3
Fourth byte of ID code: "9".
ID4
Fifth byte of ID code: "2".
ID5
Sixth byte of ID code: “9”.
54
Submit Documentation Feedback
Product Folder Links: DS90UB929-Q1
Copyright © 2014, Texas Instruments Incorporated