 English |
|
|
|
|
|
|
|
| DS90UB929-Q1 Datasheet, PDF (29/71 Pages) Texas Instruments – 720p HDMI to FPD-Link III Bridge Serializer | |||
| |||
| ◁ |
www.ti.com
DS90UB929-Q1
SNLS457 â NOVEMBER 2014
⢠COAX : Latched into DUAL_CTL1[7], COAX_MODE (0x5B[7]).
⢠REM_EDID_LOAD : Latched into BRIDGE_CFG[5] (0x54[5]).
8.4.2 FPD-Link III Single Link Operation
The DS90UB929-Q1's single link mode transmits the video over a single FPD-Link III to a single receiver. Single
link mode supports frequencies up to 96MHz for 24-bit video when paired with the DS90UB940-Q1/DS90UB948-
Q1. This mode is compatible with the DS90UB926Q-Q1/DS90UB928Q-Q1 when operating below 85MHz.
8.5 Programming
8.5.1 Serial Control Bus
This serializer may also be configured by the use of a I2C compatible serial control bus. Multiple devices may
share the serial control bus (up to 8 device addresses supported). The device address is set via a resistor divider
(R1 and R2 â see Figure 17 below) connected to the IDx pin.
VDD18
HOST
SCL
SDA
VDDI2C
R1
VR2
IDx
4.7k
4.7k
R2
SER
SCL
SDA
To other
Devices
Figure 17. Serial Control Bus Connection
The serial control bus consists of two signals, SCL and SDA. SCL is a Serial Bus Clock Input. SDA is the Serial
Bus Data Input / Output signal. Both SCL and SDA signals require an external pull-up resistor to VDD18 or VDD33.
For most applications, a 4.7k⦠pull-up resistor is recommended. However, the pull-up resistor value may be
adjusted for capacitive loading and data rate requirements. The signals are either pulled High, or driven Low.
The IDx pin configures the control interface to one of 8 possible device addresses. A pull-up resistor and a pull-
down resistor may be used to set the appropriate voltage on the IDx input pin See Table 8 below.
#
Ratio
VR2 / VDD18
1
0
2
0.208
3
0.323
4
0.440
5
0.553
6
0.668
7
0.789
8
1
Table 7. Serial Control Bus Addresses For IDx
Ideal VR2
(V)
0
0.374
0.582
0.792
0.995
1.202
1.420
1.8
Suggested Resistor Suggested Resistor
R1 k⦠(1% tol)
R2 k⦠(1% tol)
OPEN
40.2
118
30.9
107
51.1
113
88.7
82.5
102
68.1
137
56.2
210
13.3
OPEN
7-Bit Address
0x0C
0x0E
0x10
0x12
0x14
0x16
0x18
0x1A
8-Bit Address
0x18
0x1C
0x20
0x24
0x28
0x2C
0x30
0x34
Copyright © 2014, Texas Instruments Incorporated
Product Folder Links: DS90UB929-Q1
Submit Documentation Feedback
29
|
▷ |
German
Russian
Spanish
Italian
Polish
Chinese
Japanese
Korean
French
Portuguese