English
Language : 

DS90UH949-Q1 Datasheet, PDF (49/87 Pages) Texas Instruments – 1080p HDMI to FPD-Link III Bridge Serializer with HDCP
www.ti.com
DS90UH949-Q1
SNLS453 – NOVEMBER 2014
Register Maps (continued)
ADD
(dec)
30
ADD
(hex)
0x1E
Register Name
Transmitter Port
Select
31
0x1F Frequency
Counter
Bit(s)
7:3
2
1
0
7:0
Table 10. Serial Control Bus Registers (continued)
Register
Type
RW
RW
RW
RW
Default
(hex)
0x01
0x00
Function
Description
Reserved.
PORT1_I2C_E
N
Port1 I2C Enable.
Enables secondary I2C address. The second I2C address provides access to Port1
registers as well as registers that are shared between Port0 and Port1. The second I2C
address value will be set to DeviceID + 1 (7-bit format). The PORT1_I2C_EN bit must
also be set to allow accessing remote devices over the second link when the device is in
Replicate mode.
PORT1_SEL
Selects Port1 for register access from primary I2C address.
For writes, Port1 registers and shared registers will both be written.
For reads, Port1 registers and shared registers will be read. This bit must be cleared to
read Port0 registers.
This bit is ignored if PORT1_I2C_EN is set.
PORT0_SEL
Selects Port0 for register access from primary I2C address.
For writes, Port0 registers and shared registers will both be written.
For reads, Port0 registers and shared registers will be read. Note that if PORT1_SEL is
also set, then Port1 registers will be read.
This bit is ignored if PORT1_I2C_EN is set.
Frequency
Count
Frequency counter control.
A write to this register will enable a frequency counter to count the number of pixel clock
during a specified time interval. The time interval is equal to the value written multiplied
by the oscillator clock period (nominally 40ns). A read of the register returns the number
of pixel clock edges seen during the enabled interval. The frequency counter will freeze
at 0xff if it reaches the maximum value. The frequency counter will provide a rough
estimate of the pixel clock period. If the pixel clock frequency is known, the frequency
counter may be used to determine the actual oscillator clock frequency.
Copyright © 2014, Texas Instruments Incorporated
Product Folder Links: DS90UH949-Q1
Submit Documentation Feedback
49