LM3S608-IQN50-C2T Datasheet, PDF (496/538 Pages) Texas Instruments – Stellaris LM3S608 Microcontroller

Electrical Characteristics
NRND: Not recommended for new designs.
18 Electrical Characteristics
18.1
18.1.1
18.1.2
DC Characteristics
Maximum Ratings
The maximum ratings are the limits to which the device can be subjected without permanently
damaging the device.
Note: The device is not guaranteed to operate properly at the maximum ratings.
Table 18-1. Maximum Ratings
Characteristic^a
Symbol
Value
Unit
Supply voltage range (V_DD)
V_DD
0.0 to +3.6
V
Input voltage
Input voltage for a GPIO configured as an analog input
-0.3 to 5.5
V
V_IN
-0.3 to V_DD + 0.3
V
Maximum current for pins, excluding pins operating as GPIOs
I
100
mA
Maximum current for GPIO pins
I
100
mA
Maximum input voltage on a non-power pin when the
V_NON
300
mV
microcontroller is unpowered
a. Voltages are measured with respect to GND.
Important: This device contains circuitry to protect the inputs against damage due to high-static
voltages or electric fields; however, it is advised that normal precautions be taken to
avoid application of any voltage higher than maximum-rated voltages to this
high-impedance circuit. Reliability of operation is enhanced if unused inputs are
connected to an appropriate logic voltage level (for example, either GND or V_DD).
Recommended DC Operating Conditions
Table 18-2. Recommended DC Operating Conditions
Parameter Parameter Name
Min
V_DD
Supply voltage
3.0
V_IH
High-level input voltage
2.0
V_IL
Low-level input voltage
-0.3
V_OH
High-level output voltage
2.4
V_OL
Low-level output voltage
-
High-level source current, V_OH=2.4 V
2-mA Drive
2.0
I_OH
4-mA Drive
4.0
8-mA Drive
8.0
Low-level sink current, V_OL=0.4 V
2-mA Drive
2.0
I_OL
4-mA Drive
4.0
8-mA Drive
8.0
Nom
3.3
-
-
-
-
-
-
-
-
-
-
Max
Unit
3.6
V
5.0
V
1.3
V
-
V
0.4
V
-
mA
-
mA
-
mA
-
mA
-
mA
-
mA
496
June 18, 2012
Texas Instruments-Production Data