CC2520_11 Datasheet, PDF (25/133 Pages) Texas Instruments – 2.4 GHZ IEEE 802.15.4/ZIGBEE RF TRANSCEIVER

CC2520 DATASHEET
2.4 GHZ IEEE 802.15.4/ZIGBEE® RF TRANSCEIVER
SWRS068 – DECEMBER 2007
8 Functional Introduction
8.1 Integrated 2.4 GHz IEEE 802.15.4 Compliant Radio
CC2520 features a Direct Conversion Transceiver operating in the 2.4 GHz band with excellent receiver
sensitivity and robustness to interferers. The CC2520 radio complies with the IEEE 802.15.4 PHY
specification. The radio has 250 kbps data rate, 2 Mchip/s chip rate, and is suitable for systems targeting
compliance with worldwide radio frequency regulations covered by ETSI EN 300 328 and EN 300 440 class
2 (Europe), FCC CFR47 Part 15 (US) and ARIB STD-T66 (Japan).
8.2 Comparison to CC2420
CC2520 represents significant improvement over the CC2420 features and performance. A comparison is
given in the table below.
Feature
Standard
Maximum output power
Typical sensitivity
General clock output
User interface
Register access
Digital inputs
Digital outputs
Start up
Crystal frequency
Packet sniffing
Maximum SPI clock speed
RAM size
Operating voltage
Maximum operating temperature
Security
Package
RF frequency range
Table 5: Comparison of CC2420 and CC2520
CC2420
IEEE 802.15.4-2003
0 dB
-95 dBm
No
Command strobes and configuration
registers. All user control goes through the
SPI.
Possible without crystal oscillator running.
No Schmitt triggers
Fixed configuration
Manual start of XOSC
16 MHz
No hardware support
10 MHz
364 byte
2.1 – 3.6 V
85°C
Limited flexibility
QLP-48, 7x7 mm
2400-2483.5 MHz
CC2520
IEEE 802.15.4-2006
+5 dB
-98 dBm
Yes, configurable frequency 1-16MHz
Instruction set (which includes the command
strobes as a subset) and configuration
registers. Command strobes may be
triggered by GPIO pins, which gives
excellent timing control. Improved status
information.
Only possible when crystal oscillator is
running.
Schmitt triggers on all digital inputs.
Highly flexible and configurable
XOSC starts automatically after reset (by
reset_n pin). Manual start of XOSC after
SRES instruction.
32 MHz
Hardware support for non-intrusive sniffing
of both transmitted and received frames.
8 MHz
768 byte
1.8 – 3.8 V
125°C
Highly flexible security instructions. More
RAM available allows more flexible
processing.
QFN 28 (RHD), 5x5 mm
2394-2507 MHz
WWW.TI.COM
25