409-10012 Datasheet, PDF (3/26 Pages) TE Connectivity Ltd – AMP-O-MATIC Side-Feed Stripper-Crimper

409-10012
1320895-1
1320895-2
1320895-3
1320895-4
AMP-O-MATIC Side Feed Stripper-Crimper III Machine (without Crimp Quality Monitor)
AMP-O-MATIC Side Feed Stripper-Crimper III Machine (with Crimp Quality Monitor)
C.E. Version AMP-O-MATIC Side Feed Stripper-Crimper III Machine (without Crimp Quality Monitor)
C.E. Version AMP-O-MATIC Side Feed Stripper-Crimper III Machine (with Crimp Quality Monitor)
Figure 1
1. INTRODUCTION
This manual provides the information required for operation and maintenance of AMP-O-MATIC* Side Feed
Stripper-Crimper III Machine, No. 1320895-[ ]. See Figure 1. Information includes: description; receiving
inspection and installation; machine operation; preventive maintenance; adjustments; repair and replacement;
and Documentation Package. The -2 machine is available with the Crimp Quality Monitor (CQM). For further
information, contact your TE Connectivity Field Representative.
NOTE ^{Measurements in this document are in metric units [with U.S. customary units in brackets].}
i
The compact 68 kilogram [150-lb] (approximate) machine is intended for bench-top operation. The size is
approximately 355 mm wide x 457 mm deep x 838 mm high [14 in. wide x 18 in. deep x 33 in. high], including
the reel support (less terminal reel). For operation, the machine requires a constant air supply of 552 to
690 kilopascals (kPa) [80 to 100 psi] with adequate volume (1.6 liters/sec. [3.5 scfm]) to maintain a minimum
of 552 kPa [80 psi] throughout the cycle of operation. Electrical power is not required for machine operation,
however electrical power is required for the work lamp to light the “target area.”
Rev E
3 of 26