409-10012 Datasheet, PDF (11/26 Pages) TE Connectivity Ltd – AMP-O-MATIC Side-Feed Stripper-Crimper

Machine Ram
Ram Speed
Adjustment
Normal Gripper Pressure
(138-276 kPa
[20-40 psi])
Adjustable Wire
Gripper Assembly
Feed Mechanism
Foot Switch
Terminal Strip
409-10012
Shut Height Adjustable
Locking Screw
Shut Height Disc Indicator
-1, -3 Ram Cap
-2, -4 CQM^† Ram Cap
Typical Applicator Ram
Crimpers
Target Area
Scrap Shear
Wire Locator
Gripper Height
Lock Screw
†_{Crimp Quality Monitor}
Stock Drag
Gripper Height
Adjusting Screw
Figure 8
2. While raising and holding feed finger up, pull terminal strip back through strip guides until clear.
3. Roll terminal strip onto reel to prevent distortion until loaded again into machine.
4.2. Production Setup (Figure 8)
1. Check the wire disk pad settings and stripping blades for size of wire to be run.
2. Place an adequate supply of wire within easy reach of the operator's position.
3. Be sure that an adequate supply of terminals is on the reel.
4. Connect air supply and lift lockout valve to “OPEN”. Turn work light “ON”.
DANGER
Machine assembly may move when the air is turned on. To avoid personal injury, keep clear of movable tooling when
performing Step 4.
STOP
Rev E
11 of 26