409-10012 Datasheet, PDF (10/26 Pages) TE Connectivity Ltd – AMP-O-MATIC Side-Feed Stripper-Crimper

409-10012
D. Foot Valve (When Used)
When the operator is correctly positioned in front of the machine, the foot should rest on the valve comfortably
and easily. The valve should be placed on a rubber mat; this allows it to be movable and permits the operator
to shift positions to minimize fatigue, while at the same time the mat prevents the valve from sliding
unintentionally.
The preference for locating the switch varies among operators. Some like the valve located so that their foot
rests on the valve when their legs are in the natural sitting position (calf perpendicular to the floor). Others
prefer it slightly in front of the natural position. The important thing is that the foot be about 90_ to the calf
when resting on the valve. Those who prefer the valve slightly forward may require a wedge-shaped block
placed under it.
Figure 6 shows proper location and position. Figure 7 shows a typical layout for the efficient handling of
materials.
Figure 6 shows the physical considerations as recommended,
and the operator in a desirable position. Note that the chair height
and back rest are properly adjusted, and that the chair is properly
located in respect to the bench. Thus, the operator's back is
straight, and supported by the chair. Note also that the operator's
upper arms are in a direct line with the torso.
The plan view, Figure 7, identifies typical locations for “supply”
and “applied product,” and serves as an aid in visualizing the
convenience in materials handling afforded by proper setup and
correct operator positioning.
Figure 6
Figure 7
4. MACHINE OPERATION
This section pertains to loading and unloading of terminal strip, and operation of the machine in production use.
It shall be assumed that the machine has been properly installed in accordance with Section 3.
4.1. Terminal Strip Loading and Unloading (Figure 8)
A. Loading
1. Place reel of terminals on reel support and secure with flange. Strip must unreel and enter left side of
machine with wire barrels of terminals toward front of machine and with open “U” up.
2. Turn drag release lever upward to raise stock drag.
3. Feed terminal strip through strip guides until lead terminal is over anvil, then pull back slightly on strip to
assure feed pawl is properly engaged in feed point of strip.
4. Turn drag release lever down to apply drag to terminal strip.
5. After making several terminations, make sure carrier strip enters scrap shear to the right of applicator.
B. Unloading
1. Release stock drag.
Rev E
10 of 26