409-10012 Datasheet, PDF (16/26 Pages) TE Connectivity Ltd – AMP-O-MATIC Side-Feed Stripper-Crimper

Terminal Feed-Back
Stop Adjustment
Pivot
Block
409-10012
Forward Limit
Adjustment Knob
Feed Finger
Wire Grippers
Lock
Knob
Rear Strip
Guide
Wire Locator
Feed Pawl
Strip Guide Plate
Adjust Screw (Hidden)
Front Strip Guide
Figure 10
1. Determine which direction the lead terminal must be moved (advanced or retracted).
2. Loosen small lock knob under larger adjusting knob. See Figure 10.
3. To advance lead terminal, turn forward limit adjustment knob COUNTERCLOCKWISE. To retract, turn knob
CLOCKWISE.
NOTE ^{When making adjustment, keep terminal strip pulled back against feed pawl, especially during retraction adjustment.}
i
4. At completion of adjustment, tighten lock screw.
5. Make several test crimps by operating machine as described in Section 4. Observe for proper feeding of
terminal strip and centering of lead terminal over anvil. Check retraction of feed finger for slight overtravel of
feed point in terminal strip. If no overtravel exists, or if excessive, perform Step 6. If satisfactory, adjustment is
complete.
6. For more feed return, turn feed return adjustment screw OUT (refer to Figure 2). For less, turn it IN. Perform
several test crimps while making adjustment to assure feed return is proper.
Rev E
16 of 26