409-10012 Datasheet, PDF (24/26 Pages) TE Connectivity Ltd – AMP-O-MATIC Side-Feed Stripper-Crimper

409-10012
8. TROUBLESHOOTING
Figure 12 contains a list of possible problems, along with the causes of the problems and the remedies.
CAUTION
Lockout valve must be closed and air must be disconnected when cleaning, lubricating, or replacing any components,
or when repositioning any misaligned parts.
!
DANGER
To avoid personal injury, KEEP HANDS CLEAR OF ALL MOVING COMPONENTS (ram, stripping assembly, and
grippers) during troubleshooting with air pressure applied.
STOP
The following conditions are required to troubleshoot the machine in the manual mode:
1. Air supply connected;
2. Lockout valve open;
3. Minimum of 552 kPa [80 psi] on gage;
4. Front door closed; LV5 activated;
5. Remove applicator if it is felt that it may be the cause of the problem.
9. OPTIONAL PNEUMATIC COUNTER
9.1. Description
An optional pneumatic counter may be installed on the machine to total the machine cycles, and this total equals
the number of wire terminations. The counter is not supplied by TE. It may be purchased from:
ARO CORPORATION
1 ARO CENTER
BRYAN, OH 43506
When ordering the counter from the manufacturer, specify Model 59095-1, Catalog No. A-8078-L.
9.2. Pneumatic Counter Installation
The counter may be attached to the machine at any location that will not interfere with the machine operation.
Connect an air line between the counter and port 5 on power valve P1. Refer to Paragraph 2.2, Functional
Description, and to pneumatic drawing 768561.
10. RoHS INFORMATION
Information on the presence and location of any substances subject to RoHS (Restriction on Hazardous
Substances) can be found at the following website:
http://www.te.com/customersupport/productcompliance/
Click on “Check Compliance Status” and enter equipment part number.
11. REVISION SUMMARY
Since the previous version of this manual, the following changes were made:
• Replaced trademark references to PTFE.
• Updated product compliance website information.
• Simplified table of contents on first page.
• Updated document to corporate requirements.
Rev E
24 of 26