409-32035 Datasheet, PDF (2/20 Pages) TE Connectivity Ltd – AMP-O-LECTRIC Model G II

409-32035
SAFETY PRECAUTIONS — AVOID INJURY
Safeguards are designed into this application equipment to protect operators and maintenance personnel from
most hazards during equipment operation. However, certain safety precautions must be taken by the operator
and repair personnel to avoid personal injury, as well as damage to the equipment. For best results, application
equipment must be operated in a dry, dust-free environment. Do not operate equipment in a gaseous or
hazardous environment.
Carefully observe the following safety precautions before and during operation of the equipment:
Always wear approved eye protection while operating
equipment.
Use caution when working with this equipment.
Always wear appropriate ear protection while using
equipment.
Moving parts can crush and cut. Always keep guard(s)
in place during normal operation.
Never insert hands into installed equipment.
Never wear loose clothing or jewelry that may catch in
moving parts of the equipment.
Never alter, modify, or misuse the equipment.
Always insert power plug into a properly grounded
receptacle to avoid electrical shock.
Always turn off the main power switch and disconnect
the electrical cord from the power source when
performing repair or maintenance on the equipment.
Do not operate the equipment without guards in place.
Lift point for equipment.
Never enter the electrical enclosure immediately after
turning off the machine power switch and disconnecting
the electrical cord from the power source. High residual
voltages may be present in the electrical enclosure.
Read the warning label on the electrical enclosure lid
before entering the enclosure.
Never stare at the bright light used for machine lighting.
Bright light can damage the eye.
Never use the machine for other than what it is
designed, which is crimping terminals to wire. Do not
use the machine for crushing any items.
TOOLING ASSISTANCE CENTER
CALL TOLL FREE 1-800-722-1111 (CONTINENTAL UNITED STATES AND PUERTO RICO ONLY)
The Tooling Assistance Center offers a means of providing technical assistance when required. In addition,
Field Service Specialists are available to provide assistance in the adjustment or repair of the application
equipment when problems arise which your maintenance personnel are unable to correct.
INFORMATION REQUIRED WHEN CONTACTING THE TOOLING ASSISTANCE CENTER
When calling the Tooling Assistance Center regarding service to equipment, it is suggested that a person
familiar with the device be present with a copy of the manual (and drawings) to receive instructions. Many
difficulties can be avoided in this manner.
When calling the Tooling Assistance Center, be ready with the following information:
1. Customer name
2. Customer address
3. Person to contact (name, title,
telephone number, and extension)
6. Product part number (and serial number
if applicable)
7. Urgency of request
8. Nature of problem
4. Person calling
9. Description of inoperative component(s)
5. Equipment number (and serial number if
applicable)
10. Additional information/comments that
may be helpful
Rev C
2 of 20