409-32035 Datasheet, PDF (17/20 Pages) TE Connectivity Ltd – AMP-O-LECTRIC Model G II

409-32035
Standard Guard Insert PN 1-679532-0 and Guard Insert PN 679994-2
1. Slide the insert into the rear slot of the guard door. Secure the insert to the door with two screws
placed through the large square holes in the left guard door and into the threaded holes in the top of
the insert. Do not tighten the screws.
2. Move the insert horizontally and vertically as needed to align the slot with the crimp area of applicator.
3. Tighten the screws.
Guard Insert PN 354529-2 and Guard Insert PN 679995-2
1. Slide the insert into the front slot of the guard door. Secure the insert to the door with two screws
placed through the large square holes of the insert and into the threaded holes in the bottom of the left
guard door. Do not tighten the screws.
2. Move the insert horizontally and vertically as needed to align slot with crimp area of the applicator.
3. Tighten the screws.
7. MACHINE OPTIONS AND INSTALLATION OF THE AIR FEED VALVE ASSEMBLY
The following machine options are available for the AMP-O-LECTRIC Model G II Terminator Machine:
PART NUMBER
2217339-1
354550-3
1428156-1
DESCRIPTION
Air Feed Valve Kit
Lubricator Bowl Assembly
Shoulder Eye Bolt
Figure 14
PURPOSE
Required to run certain air-feed type applicators
Pre-lubricates the strip
Provides a lift point for machine installation
To install the Air Feed Kit PN 2217339-1, proceed as follows:
DANGER
To avoid personal injury, be sure to turn “off" the machine, and disconnect it from the power source.
Follow Step 2 “Installation Procedure for Customer Use” on the air feed kit PN 2217339 included with Air Feed
Kit PN 2217339-1 (Figure 15).
1. Disconnect power.
2. Remove reel and reel support.
3. Loosen thumbscrews and remove terminal lead-in.
4. Remove four motor guard screws and motor guard.
5. Remove air feed kit guard knockouts - save piece with holes in it.
6. Remove top cover access panel.
7. Remove four recessed screws from top cover.
8. Carefully lift top cover, flip over, and lay on right side guard.
9. Remove four screws from electrical box cover and cover.
10. Mount item 100 (air feed kit) to inside of right side guard with filter going through knockout to exterior
of guard.
11. Assemble knockout piece to bottom of right side guard shown using items 103 (screw) and 102 (nut).
12. Cut wire tie holding door interlock wire and using item 104 (wire tie), bundle door interlock wire and
item 101 (air feed cable) to right side guard.
13. Route item 101 (air feed cable) through gap in right side guard with door interlock cable.
14. Unscrew indicated cable gland using care not to damage existing wire going through it.
15. Route item 101 (air feed cable) through cable gland into electrical box.
16. Plug item 101 (air feed cable) into connector J17 on pc board.
Rev C
17 of 20