W83977EG-AW Datasheet, PDF (103/142 Pages) Nuvotem Talema – These products are not designed for use in life support appliances

W83977EF-AW/W83977EG-AW
= 01 Select 1st alternate function: Power LED output. Please refer to TABLE C
= 1x Reserved
Bit 2: Reserved.
Bit 1: Polarity: 1: Invert, 0: No Invert
Bit 0: In/Out: 1: Input, 0: Output
TABLE C
WDT_CTRL1* BIT[1]*
1
WDT_CTRL0* BIT[3] WDT_CTRL1 BIT[0] POWER LED STATE
X
X
1 Hertz Toggle pulse
0
0
X
Continuous high or low*
0
1
0
Continuous high or low*
0
1
1
1 Hertz Toggle pulse
*Note: 1). Regarding to the contents of WDT_CTR1 and WDT_CTRL0, please refer to CRF3 and CRF4 in Logic Device 8.
2). Continuous high or low depends on the polarity bit of GP13 or GP17 configure registers.
CRF1 ( Default 0x00)
General Purpose Read/Write Enable*
Bit 7 - 2: Reserved
Bit 1:
= 1 Enable GP15 General Purpose Address Decode
= 0 Disable GP15 General Purpose Address Decode
Bit 0:
= 1 Enable GP14 General Purpose Address Decode
= 0 Disable GP14 General Purpose Address Decode
*Note: If the logical device's activate bit is not set then bit 0 and 1 have no effect.
12.8 Logical Device 8 (GP I/O Port II)
CR30 (Default 0x00)
Bit 7 - 1: Reserved.
Bit 0: = 1 Activates the logical device.
= 0 Logical device is inactive.
CR60, CR 61 (Default 0x00, 0x00)
These two registers select GP2 & Watch Dog I/O base address [0x100:0xFFE] on 2 byte
boundary. I/O base address + 1: Watch Dog I/O base address.
CR70 (Default 0x00)
Bit 7 - 4: Reserved.
Bit 3 - 0: These bits select IRQ resource for Common IRQ of GP20~GP26 at Logic Device 8.
CR72 (Default 0x00)
-101-
Publication Release Date: Apr. 2006
Revision 1.2