SI5374 Datasheet, PDF (68/69 Pages) Silicon Laboratories – 4-PLL ANY-FREQUENCY PRECISION CLOCK MULTIPLIER/JITTER ATTENUATOR

Si5374
DOCUMENT CHANGE LIST
Revision 0.1 to Revision 0.2
 Added 1.8 V operation.
 Added 40 MHz reference oscillator
 Corrected Figure 10 title.
 Added comment to SFOUT register.
Revision 0.2 to Revision 0.3
 Updated and reordered spec tables.
Revision 0.3 to Revision 0.4
 Added Silicon Labs logo to device top mark.
Revision 0.4 to Revision 0.45
 Added comments indicating that a crystal may not be
used in place of an external oscillator.
 Updated specification Tables 3, 4, and 5.
 Added maximum jitter specifications to Table 5.
 Added Thermal Characteristics table on page 12.
 Added Figure 3, “Typical Phase Noise Plot,” on page
14.
 Added "5. Si5374 Application Examples and
Suggestions" on page 17.
 Updated "7. Register Descriptions" on page 22.
 Added a part number for the non-RoHS6 device to
"9. Ordering Guide" on page 63.
 Added recommendations on the four reset pins in
"5.4. RSTL_x Pins" on page 17.
 Added Lead-Finish top marking.
Revision 0.45 to Revision 1.0
 Updated " Features" on page 1.
Revised output jitter values.
 Minor corrections to Tables 2 and 3.
 Added maximum lock and settle time specs to
Table 5.
 Updated "5.5. Reference Oscillator Selection" on
page 17.
Revised Si530 part number.
 Added warning about MEMS reference oscillators to
"5.5. Reference Oscillator Selection" on page 17.
 Added Table 10 in "7.1. ICAL" on page 56.
Revision 1.0 to Revision 1.1
 Added reference to AN803 on pages 11, 16, 31 and
60.
 Added additional LOL and Settling Time Specs on
page 11.
 Added new part numbers on page 63.
 Updates to LOS1_EN and LOS2_EN on pages 53
and 54.
68
Rev. 1.1