M37517F8HP Datasheet, PDF (85/98 Pages) Renesas Technology Corp – SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER

7517 Group
ELECTRICAL CHARACTERISTICS
Table 20 Absolute maximum ratings (Executing flash memory mode, flash memory electrical characteristics is applied.)
Symbol
VCC
VI
VI
VI
VI
VO
VO
Pd
Topr
Tstg
Parameter
Power source voltage
Input voltage P00–P07, P10–P17, P20, P21,
P24–P27, P30–P35, P40–P45,
ADVREF, AVCC, ISENS1
Input voltage P22, P23
Input voltage RESET, XIN
Input voltage CNVSS
Output voltage P00–P07, P10–P17, P20, P21,
P24–P27, P30–P35, P40–P45,
XOUT
Output voltage P22, P23
Power dissipation
Operating temperature
Storage temperature
Conditions
All voltages are based on VSS.
Output transistors are cut off.
Ta = 25 °C
Ratings
Unit
–0.3 to 6.5
V
–0.3 to VCC +0.3
V
–0.3 to 5.8
V
–0.3 to VCC +0.3
V
–0.3 to VCC +0.3
V
–0.3 to VCC +0.3
V
–0.3 to 5.8
V
300
mW
–20 to 85
°C
–40 to 125
°C
Table 21 Recommended operating conditions (1)
(VCC = 3.0 to 3.6 V, Ta = –20 to 85 °C, unless otherwise noted)
Symbol
VCC
VSS
ADVREF
ADVSS
VIA
AVCC
AVSS
ISENS0
ISENS1
VIH
VIH
VIH
VIH
VIH
VIH
VIL
VIL
VIL
VIL
VIL
Parameter
Power source voltage At 4 MHz
When using current integrator, over current detector, 32 kHz RC oscillation circuit
Power source voltage
A/D convert reference voltage
A/D convert power source voltage
Analog input voltage
AN0–AN5, AN8–AN11
Analog power source voltage
Analog power source voltage
Analog input voltage
Analog input voltage
“H” input voltage
P00–P07, P10–P17, P20–P27, P30–P35, P40–P45
“H” input voltage (when I²C-BUS input level is selected)
SDA1, SCL1
“H” input voltage (when I²C-BUS input level is selected)
SDA2, SCL2
“H” input voltage (when SMBUS input level is selected)
SDA1, SCL1
“H” input voltage (when SMBUS input level is selected)
SDA2, SCL2
“H” input voltage
RESET, XIN, CNVSS
“L” input voltage
P00–P07, P10–P17, P20–P27, P30–P35, P40–P45
“L” input voltage (when I²C-BUS input level is selected)
SDA1, SDA2, SCL1, SCL2
“L” input voltage (when SMBUS input level is selected)
SDA1, SDA2, SCL1, SCL2
“L” input voltage
RESET, CNVSS
“L” input voltage
XIN
Min.
3.0
3.234
2.0
ADVSS
3.234
-0.1
0.8VCC
0.7VCC
0.7VCC
1.4
1.4
0.8VCC
0
0
0
0
0
Limits
Unit
Typ. Max.
3.3
3.6
V
3.3 3.366
0
V
VCC
V
0
V
VCC
V
3.3 3.366 V
0
V
0
V
0.1
V
VCC
V
5.8
V
VCC
V
5.8
V
VCC
V
VCC
V
0.2VCC V
0.3VCC V
0.6
V
0.2VCC V
0.16VCC V
Rev.1.01 Aug 02, 2004 page 85 of 96