RX23T Datasheet, PDF (47/98 Pages) Renesas Technology Corp – 40-MHz 32-bit RX MCUs, built-in FPU, 65.6 DMIPS

RX23T Group
5. Electrical Characteristics
Table 5.10 DC Characteristics (8)
Conditions: VCC = 2.7 V to 5.5 V, AVCC0 = VREFH0 = VCC to 5.5 V, VSS = AVSS0 = VREFL0 = 0 V, T_a = –40 to +105°C
The ripple voltage must meet the allowable ripple frequency f_{r (VCC)} within the range between the VCC upper limit (5.5 V) and
lower limit (2.7 V). When VCC change exceeds VCC ±10%, the allowable voltage change rising/falling gradient dt/dVCC must be
met.
Item
Symbol
Min.
Typ.
Max.
Unit
Test Conditions
Allowable ripple frequency f_{r (VCC)}
—
—
10
kHz Figure 5.3
V_{r (VCC)} ≤ VCC × 0.2
—
—
1
MHz Figure 5.3
V_{r (VCC)} ≤ VCC × 0.08
—
—
10
MHz Figure 5.3
V_{r (VCC)} ≤ VCC × 0.06
Allowable voltage change dt/dVCC
1.0
—
—
ms/V When VCC change exceeds VCC ±10%
rising/falling gradient
VCC
1 / f_{r (VCC)}
V_{r (VCC)}
Figure 5.3
Ripple Waveform
Table 5.11 DC Characteristics (9)
Conditions: VCC = 2.7 V to 5.5 V, AVCC0 = VREFH0 = VCC to 5.5 V, VSS = AVSS0 = VREFL0 = 0 V, T_a = –40 to +105°C
Item
Symbol
Min.
Typ.
Max.
Unit
Test Conditions
Permissible error of VCL pin external
C_VCL
3.3
4.7
6.1
μF
capacitance
Note: The recommended capacitance is 4.7 μF. Variations in connected capacitors should be within the above range.
Table 5.12 Permissible Output Currents
Conditions: VCC = 2.7 V to 5.5 V, AVCC0 = VREFH0 = VCC to 5.5 V, VSS = AVSS0 = VREFL0 = 0 V, T_a = –40 to +105°C
Item
Symbol Max.
Unit
Permissible output low current
Large current ports (Ports 71 to 76, port B5, port D3)
RIIC pins
I_OL
10.0
mA
6.0
Ports other than above
Normal output mode
4.0
High-drive output mode
8.0
Permissible output low current
Total of large current ports
Total of all output pins
I_OL
50
110
Permissible output high current
Large current ports (Ports 71 to 76, port B5, port D3)
Ports other than above
Normal output mode
I_OH
–5.0
–4.0
High-drive output mode
–8.0
Permissible output high current
Total of large current ports
Total of all output pins
I_OH
–25
–35
Note: Do not exceed the permissible total supply current.
R01DS0248EJ0110 Rev.1.10
Jan 13, 2016
Page 47 of 98