RX23T Datasheet, PDF (41/98 Pages) Renesas Technology Corp – 40-MHz 32-bit RX MCUs, built-in FPU, 65.6 DMIPS

RX23T Group
5. Electrical Characteristics
5. Electrical Characteristics
5.1 Absolute Maximum Ratings
Table 5.1
Absolute Maximum Ratings
Conditions: VSS = AVSS0 = VREFL0 = 0 V
Item
Symbol
Value
Unit
Power supply voltage
VCC
–0.3 to +6.5
V
Input voltage
Port 4
V_in
Except for port 4 and ports for 5 V
tolerant*¹
Ports for 5 V tolerant*¹
-0.3 to AVCC0+0.3
V
–0.3 to VCC+0.3
V
–0.3 to +6.5
V
Reference power supply voltage
VREFH0
–0.3 to AVCC0+0.3
V
Analog power supply voltage
AVCC0
–0.3 to +6.5
V
Analog input
When AN000 to AN007 used
V_AN
voltage
When AN016 and AN017 used
Operating temperature*²
T_opr
Storage temperature
T_stg
–0.3 to AVCC0+0.3
V
–0.3 to VCC+0.3
–40 to +85
°C
–40 to +105
–55 to +125
°C
Caution: Permanent damage to the MCU may result if absolute maximum ratings are exceeded.
To preclude any malfunctions due to noise interference, insert capacitors of high frequency characteristics between the VCC and
VSS pins, between the AVCC0 and AVSS0 pins, between the VREFH0 and VREFL0 pins. Place capacitors of about 0.1 μF as
close as possible to every power supply pin and use the shortest and heaviest possible traces.
Connect the VCL pin to a VSS pin via a 4.7 μF capacitor. The capacitor must be placed close to the pin.
Do not input signals or an I/O pull-up power supply to ports other than 5-V tolerant ports while the device is not powered.
The current injection that results from input of such a signal or I/O pull-up may cause malfunction and the abnormal current that
passes in the device at this time may cause degradation of internal elements.
Even if –0.3 to +6.5 V is input to 5-V tolerant ports, it will not cause problems such as damage to the MCU.
Note 1. Ports B1 and B2 are 5 V tolerant.
Note 2. The upper limit of operating temperature is 85°C or 105°C, depending on the product. For details, refer to section 1.2, List of
Products.
Table 5.2
Recommended Operating Voltage Conditions
Item
Symbol
Power supply voltages
VCC^{*1, *2}
VSS
Analog power supply voltages AVCC0^{*1, *2}
VREFH0^{*1, *2}
AVSS0, VREFL0
Conditions
Min.
Typ.
Max.
Unit
2.7
—
5.5
V
—
0
—
VCC
—
5.5
V
—
AVCC0
—
—
0
—
Note 1. AVCC0/VREFH0 and VCC can be set individually within the operating range.
Note 2. When powering on the VCC and AVCC0/VREFH0 pins, power them on at the same time or the VCC pin first and then the
AVCC0/VREFH0 pin.
R01DS0248EJ0110 Rev.1.10
Jan 13, 2016
Page 41 of 98