MC68HC705C8A Datasheet, PDF (111/222 Pages) Motorola, Inc – HCMOS Microcontroller Unit

EPROM/OTPROM (PROM)
PROM Programming Routines
9.4.4 Secure PROM and Verify
This routine is used after the PROM is programmed successfully to
verify the contents of the MCU PROM against the contents of the
EPROM and then to secure the PROM. To accomplish this routine, take
these steps:
1. Set switch 1 in the ON position (restores V_DD).
2. Restore V_PP power to the programming board.
3. Set switches S4 and S6 in the OFF position.
4. Set switches S3 and S5 in the ON position.
5. Set switch 2 in the OUT position (routine is activated).
Execution time for this routine is about one second.
6. Set switch 2 in the RESET position when the routine is completed.
No LED is illuminated during this routine. Further, the end of the routine
does not mean that the SEC bit was verified. To ensure that security is
properly enabled, attempt to perform another verify routine. If the green
LED does not light, the PROM has been secured properly.
9.4.5 Secure PROM and Dump
This routine is used after the PROM is successfully programmed to
dump the contents of the MCU PROM through the SCI (binary upload)
and then to secure the PROM. To accomplish this routine, take these
steps:
1. Set switch 1 in the ON position (restores V_DD).
2. Restore V_PP power to the programming board.
3. Set switch S6 in the OFF position.
4. Set switches S3, S4, and S5 in the ON position.
5. Set switch 2 in the OUT position (routine is activated).
Execution time for this routine is about one second.
6. Set switch 2 in the RESET position when the routine is completed.
MC68HC705C8A — Rev. 2.0
MOTOROLA
EPROM/OTPROM (PROM)
Technical Data
111