N25Q00AA11GSF40F Datasheet, PDF (69/89 Pages) Micron Technology – Micron Serial NOR Flash Memory 3V, Multiple I/O, 4KB Sector Erase

1Gb, 3V, Multiple I/O Serial NOR Flash Memory
ADDRESS MODE Operations – Enter and Exit 4-Byte Address
Mode
ADDRESS MODE Operations – Enter and Exit 4-Byte Address Mode
ENTER or EXIT 4-BYTE ADDRESS MODE Command
Both ENTER 4-BYTE ADDRESS MODE and EXIT 4-BYTE ADDRESS MODE commands
share the same requirements.
To enter or exit the 4-byte address mode, the WRITE ENABLE command must be execu-
ted to set the write enable latch bit to 1. S# must be driven LOW. The command must be
input on DQn. The effect of the command is immediate; after the command has been
executed, the write enable latch bit is cleared to 0.
The default address mode is three bytes, and the device returns to the default upon exit-
ing the 4-byte address mode.
PDF: 09005aef8480cede
n25q_1gb_3V_65nm.pdf - Rev. M 03/14 EN
69
Micron Technology, Inc. reserves the right to change products or specifications without notice.
© 2011 Micron Technology, Inc. All rights reserved.