PIC16F1933_11 Datasheet, PDF (95/430 Pages) Microchip Technology – 28-Pin Flash-Based, 8-Bit CMOS Microcontrollers LCD Driver and nanoWatt XLP Technology

PIC16(L)F1933
8.0 LOW DROPOUT (LDO)
VOLTAGE REGULATOR
The PIC16F193X has an internal Low Dropout
Regulator (LDO) which provides operation above 3.6V.
The LDO regulates a voltage for the internal device
logic while permitting the VDD and I/O pins to operate
at a higher voltage. There is no user enable/disable
control available for the LDO, it is always active. The
PIC16LF193X operates at a maximum VDD of 3.6V and
does not incorporate an LDO.
A device I/O pin may be configured as the LDO voltage
output, identified as the VCAP pin. Although not
required, an external low-ESR capacitor may be con-
nected to the VCAP pin for additional regulator stability.
The VCAPEN<1:0> bits of Configuration Word 2 deter-
mines which pin is assigned as the VCAP pin. Refer to
Table 8-1.
On power-up, the external capacitor will load the LDO
voltage regulator. To prevent erroneous operation, the
device is held in Reset while a constant current source
charges the external capacitor. After the cap is fully
charged, the device is released from Reset. For more
information on recommended capacitor values and the
constant current rate, refer to the LDO Regulator
Characteristics Table in the applicable Electrical
Specifications Chapter.
TABLE 8-1: VCAPEN<1:0> SELECT BITS
VCAPEN<1:0>
Pin
00
RA0
01
RA5
10
RA6
11
No Vcap
TABLE 8-2: SUMMARY OF CONFIGURATION WORD WITH LDO
Name Bits Bit -/7
Bit -/6
Bit 13/5 Bit 12/4 Bit 11/3 Bit 10/2 Bit 9/1
CONFIG2
Legend:
Note 1:
13:8
—
—
LVP
DEBUG
—
BORV
7:0
—
—
VCAPEN1⁽¹⁾ VCAPEN0⁽¹⁾
—
—
— = unimplemented locations read as ‘0’. Shaded cells are not used by LDO.
PIC16F1933 only.
STVREN
WRT1
Bit 8/0
PLLEN
WRT0
Register
on Page
52
 2011 Microchip Technology Inc.
Preliminary
DS41575A-page 95