PIC16F1933_11 Datasheet, PDF (371/430 Pages) Microchip Technology – 28-Pin Flash-Based, 8-Bit CMOS Microcontrollers LCD Driver and nanoWatt XLP Technology

PIC16(L)F1933
FIGURE 30-4:
VDD
POR AND POR REARM WITH SLOW RISING VDD
VPOR
VPORR
VSS
NPOR
POR REARM
VSS
TVLOW⁽²⁾
TPOR⁽³⁾
Note 1:
2:
3:
When NPOR is low, the device is held in Reset.
TPOR 1 s typical.
TVLOW 2.7 s typical.
30.2 DC Characteristics: PIC16(L)F1933-I/E (Industrial, Extended)
PIC16LF1933
PIC16F1933
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C  TA  +85°C for industrial
-40°C  TA  +125°C for extended
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C  TA  +85°C for industrial
-40°C  TA  +125°C for extended
Param
No.
Device
Characteristics
Min. Typ† Max. Units
VDD
Conditions
Note
Supply Current (IDD)^{(1, 2)}
D009 LDO Regulator
—
350
—
A
— HS, EC OR INTOSC/INTOSCIO (8-16 MHZ)
Clock modes with all VCAP pins disabled
—
50
—
A
— All VCAP pins disabled
—
30
—
A
— VCAP enabled on RA0, RA5 or RA6
—
5
—
A
— LP Clock mode and Sleep (requires FVR and
BOR to be disabled)
D010
Legend:
Note 1:
2:
3:
4:
5:
6:
—
8.0
14
A
1.8 FOSC = 32 kHz
—
12
18
A
3.0 ^{LP Oscillator mode (Note 4),}
-40°C  TA  +85°C
TBD = To Be Determined
The test conditions for all IDD measurements in active operation mode are: OSC1 = external square wave, from
rail-to-rail; all I/O pins tri-stated, pulled to VDD; MCLR = VDD; WDT disabled.
The supply current is mainly a function of the operating voltage and frequency. Other factors, such as I/O pin loading
and switching rate, oscillator type, internal code execution pattern and temperature, also have an impact on the current
consumption.
For RC oscillator configurations, current through REXT is not included. The current through the resistor can be extended
by the formula IR = VDD/2REXT (mA) with REXT in k
FVR and BOR are disabled.
0.1 F capacitor on VCAP (RA0).
8 MHz crystal oscillator with 4x PLL enabled.
 2011 Microchip Technology Inc.
Preliminary
DS41575A-page 371