English
Language : 

PIC16F1933_11 Datasheet, PDF (116/430 Pages) Microchip Technology – 28-Pin Flash-Based, 8-Bit CMOS Microcontrollers LCD Driver and nanoWatt XLP Technology
PIC16(L)F1933
REGISTER 11-6: EECON2: EEPROM CONTROL 2 REGISTER
W-0/0
bit 7
W-0/0
W-0/0
W-0/0
W-0/0
EEPROM Control Register 2
W-0/0
W-0/0
W-0/0
bit 0
Legend:
R = Readable bit
S = Bit can only be set
‘1’ = Bit is set
W = Writable bit
x = Bit is unknown
‘0’ = Bit is cleared
U = Unimplemented bit, read as ‘0’
-n/n = Value at POR and BOR/Value at all other Resets
bit 7-0
Data EEPROM Unlock Pattern bits
To unlock writes, a 55h must be written first, followed by an AAh, before setting the WR bit of the
EECON1 register. The value written to this register is used to unlock the writes. There are specific
timing requirements on these writes. Refer to Section 11.2.2 “Writing to the Data EEPROM
Memory” for more information.
TABLE 11-3: SUMMARY OF REGISTERS ASSOCIATED WITH DATA EEPROM
Name Bit 7
Bit 6
Bit 5
Bit 4
Bit 3
Bit 2
Bit 1
Bit 0
Register
on Page
EECON1 EEPGD CFGS
LWLO
FREE WRERR WREN
WR
RD
115
EECON2
EEPROM Control Register 2 (not a physical register)
103*
EEADRL
EEADRL<7:0>
114
EEADRH
—
EEADRH<6:0
114
EEDATL
EEDATL<7:0>
114
EEDATH
—
—
EEDATH<5:0>
114
INTCON
GIE
PEIE TMR0IE INTE
IOCIE TMR0IF INTF
IOCIF
86
PIE2
OSFIE C2IE
C1IE
EEIE
BCLIE LCDIE
—
CCP2IE
88
PIR2
OSFIF
C2IF
C1IF
EEIF
BCLIF LCDIF
—
CCP2IF
91
Legend: — = unimplemented location, read as ‘0’. Shaded cells are not used by data EEPROM module.
* Page provides register information.
DS41575A-page 116
Preliminary
 2011 Microchip Technology Inc.