PIC16F1933_11 Datasheet, PDF (84/430 Pages) Microchip Technology – 28-Pin Flash-Based, 8-Bit CMOS Microcontrollers LCD Driver and nanoWatt XLP Technology

PIC16(L)F1933
FIGURE 7-3:
INT PIN INTERRUPT TIMING
OSC1
Q1 Q2 Q3 Q4 Q1 Q2 Q3 Q4 Q1 Q2 Q3 Q4 Q1 Q2 Q3 Q4 Q1 Q2 Q3 Q4
CLKOUT ⁽³⁾
(4)
INT pin
INTF
(1)
(1)
(5)
Interrupt Latency ⁽²⁾
GIE
INSTRUCTION FLOW
PC
PC
Instruction
Fetched
Inst (PC)
PC + 1
Inst (PC + 1)
PC + 1
—
0004h
Inst (0004h)
0005h
Inst (0005h)
Instruction
Executed
Inst (PC – 1)
Inst (PC)
Dummy Cycle
Dummy Cycle
Inst (0004h)
Note 1:
2:
3:
4:
5:
INTF flag is sampled here (every Q1).
Asynchronous interrupt latency = 3-5 TCY. Synchronous latency = 3-4 TCY, where TCY = instruction cycle time.
Latency is the same whether Inst (PC) is a single cycle or a 2-cycle instruction.
CLKOUT not available in all Oscillator modes.
For minimum width of INT pulse, refer to AC specifications in the applicable Electrical Specifications Chapter.
INTF is enabled to be set any time during the Q4-Q1 cycles.
DS41575A-page 84
Preliminary
 2011 Microchip Technology Inc.