PIC18FXXK80 Datasheet, PDF (48/52 Pages) Microchip Technology – Flash Microcontroller Programming Specification

PIC18FXXK80 FAMILY
6.0 AC/DC CHARACTERISTICS TIMING REQUIREMENTS
FOR PROGRAM/VERIFY TEST MODE (CONTINUED)
Standard Operating Conditions
Operating Temperature: 25C is recommended
Param
No.
Sym
Characteristic
Min
Max Units
Conditions
P11 TDLY7 Delay to allow Self-Timed Data Write or
Block Erase to Occur
5
— ms
P11A TDRWT Data Write Polling Time
4
— ms
P12 THLD2 Input Data Hold Time from MCLR/VPP/RE3 
250
— s
P13 TSET2 VDD Setup Time to MCLR/VPP/RE3 
100
— ns
P14 TVALID Data Out Valid from PGC 
10
— ns
P15 TDLY8 Delay between Last PGC  and MCLR/VPP/RE3 
0
—
s
P16 THLD3 MCLR/VPP/RE3 to VDD 
—
100 ns
P17 THLD3 MCLR/VPP/RE3 to VDD
—
100 ns
Note 1:
Do not allow excess time when transitioning MCLR between VIL and VIHH; this can cause spurious program
executions to occur. The maximum transition time is:
1 TCY + TPWRT (if enabled) + 1024 TOSC (for LP, HS, HS/PLL and XT modes only) +
2 ms (for HS/PLL mode only) + 1.5 s (for EC mode only)
where TCY is the instruction cycle time, TPWRT is the Power-up Timer period and TOSC is the oscillator period. For
specific values, refer to the Electrical Characteristics section of the device data sheet for the particular device.
DS39972B-page 48
 2011 Microchip Technology Inc.