PIC18FXXK80 Datasheet, PDF (1/52 Pages) Microchip Technology – Flash Microcontroller Programming Specification

PIC18FXXK80 FAMILY
Flash Microcontroller Programming Specification
1.0 DEVICE OVERVIEW
This document includes the programming specifications
for the following devices:
• PIC18F25K80
• PIC18LF25K80
• PIC18F45K80
• PIC18LF45K80
• PIC18F65K80
• PIC18LF65K80
• PIC18F26K80
• PIC18LF26K80
• PIC18F46K80
• PIC18LF46K80
• PIC18F66K80
• PIC18LF66K80
2.0 PROGRAMMING OVERVIEW
The PIC18FXXK80 family of devices can be
programmed using the In-Circuit Serial Programming™
(ICSP™) method. This programming specification
applies to the PIC18FXXK80 family of devices in all
package types.
2.1 Hardware Requirements
When programming with the ICSP, the PIC18FXXK80
family requires two programmable power supplies; one
for VDD and one for MCLR/VPP/RE3. Both supplies
should have a minimum resolution of 0.25V. Refer to
Section 6.0 “AC/DC Characteristics Timing
Requirements for Program/Verify Test Mode” for
additional hardware parameters.
2.1.1
LOW-VOLTAGE ICSP™
PROGRAMMING
In Low-Voltage ICSP mode, the PIC18FXXK80 family
can be programmed using a VDD source in the operat-
ing range. The MCLR/VPP/RE3 pin does not have to be
brought to a different voltage, but can instead, be left at
the normal operating voltage. Refer to Section 6.0
“AC/DC Characteristics Timing Requirements for
Program/Verify Test Mode” for additional hardware
parameters.
2.2 Pin Diagrams
The pin diagrams for the PIC18FXXK80 family are
shown in Figure 2-1 and Figure 2-2.
TABLE 2-1: PIN DESCRIPTIONS (DURING PROGRAMMING): PIC18FXXK80 FAMILY
Pin Name
Pin Name
Pin Type
During Programming
Pin Description
MCLR/VPP/RE3
VDD⁽¹⁾
VSS⁽¹⁾
VPP
VDD
VSS
P
Programming Enable
P
Power Supply
P
Ground
AVDD
AVDD
P
Analog Power Supply
AVSS
AVSS
P
Analog Ground
RB6
PGC
I
Serial Clock
RB7
PGD
I/O
Serial Data
VDDCORE/
VCAP
VDDCORE
VCAP
P
Regulated Power Supply for Microcontroller Core
I
Filter Capacitor for On-Chip Voltage Regulator
Legend: I = Input, O = Output, P = Power
Note 1: All power supply (VDD) and ground (VSS) pins must be connected.
 2011 Microchip Technology Inc.
DS39972B-page 1