LAN8810I-AKZE Datasheet, PDF (45/100 Pages) Microchip Technology – GMII 10/100/1000 Ethernet Transceiver with HP Auto-MDIX Support

4.2.1
Basic Control Register
Index (In Decimal): 0
GMII 10/100/1000 Ethernet Transceiver with HP Auto-MDIX Support
Datasheet
Size:
16 bits
BITS
DESCRIPTION
15 PHY Soft Reset (RESET)
1 = PHY software reset. This bit is self-clearing. When setting this bit, do not
set other bits in this register. The configuration is set from the register bit
values as described in Section 3.6.2, "Software Reset," on page 27.
Note: The PHY will be in the normal mode after a PHY software reset.
14 Loopback
0 = normal operation
1 = loopback mode
13 Speed Select[0]
Together with Speed Select[1], sets speed per the following table:
[Speed Select1][Speed Select 0]
00 = 10Mbps
01 = 100Mbps
10 = 1000Mbps
11 = Reserved
Note: Ignored if the Auto-Negotiation Enable bit of this register is 1.
12 Auto-Negotiation Enable
0 = disable auto-negotiate process
1 = enable auto-negotiate process (overrides the Speed Select[0], Speed
Select[1], and Duplex Mode bits of this register)
11 Power Down
0 = normal operation
1 = General power down mode
Note: Auto-Negotiation Enable must be cleared before setting this bit.
10 Isolate
0 = normal operation
1 = electrical isolation of PHY from GMII
9
Restart Auto-Negotiate
0 = normal operation
1 = restart auto-negotiate process
Note: Bit is self-clearing.
8
Duplex Mode
0 = half duplex
1 = full duplex
Note: Ignored if the Auto-Negotiation Enable bit of this register is 1.
7
Collision Test
0 = disable COL test
1 = enable COL test
6
Speed Select[1]
See description for Speed Select[0] for details.
5:0 RESERVED
TYPE
R/W
SC
R/W
R/W
R/W
R/W
R/W
R/W
SC
R/W
R/W
RO
RO
DEFAULT
0b
0b
Note 4.1
Note 4.1
0b
0b
0b
Note 4.1
0b
Note 4.1
-
Note 4.1 The default is determined by the CONFIG[3:2] pins as described in Section 3.8.1.2.3,
"Configuration Bits Impacted by the Mode of Operation," on page 33“
SMSC LAN8810/LAN8810i
45
DATASHEET
Revision 1.0 (02-06-13)